ABAC G-813 6pcs Tool Kit Instruction Manual
- June 1, 2024
- ABAC
Table of Contents
PNEUMATIC KIT
2809900111
04/2021
A5
| |
---|---|---
Air pressure max| EDU| 8
Spray pipe length| [mm]| 400
weight| [kg]| 0,3
Air inlet (BSP)| [inch]| ¼” i
MAX 8 bar 116psi
SAFETY WARNINGS:
- Never point the tool at yourself or other persons.
- Do not use the tool improperly
- Always disconnect the tool when not in use.
- Keep the tool out of reach of children
WARNING! WHEN USING THE TOOL, MAKE SURE THAT THERE ARE NO NAKED FLAMES OR FLAMMABLE FUMES IN THE WORKING ENVIRONMENT, WEAR A PROTECTIVE MASK AND ALWAYS DISCONNECT THE TOOL WHEN NOT IN USE.
1. OPERATING PROCEDURES:
Connect the compressed air supply to fitting A. Connect the inflation fitting B to the valve of the wheel and check the pressure on gauge C. Press the trigger D to inflate and keep checking the pressure on the gauge: if the pressure is too high, press trigger D half-way to restore the correct pressure. To avoid damages to the pressure gauge do not let the tire inflator fall on hard surfaces, in order to ensure a correct pressue value reading.
Use one of the adapters included into the kit (E) to inflate bikes inner tubes, balls or other devices
MAINTENANCE:
Disconnect the air supply during maintenance on the tool.
Regularly clean and dry the filter in the system and the pneumatic tool air inlet opening.
Lubricate any quick-disconnect coupling on the system to prevent jamming.
Drain condensation from air filter and from the compressor on a daily basis.
In order to avoid rust formation and to minimize wear, clean and lubricate the tool after each use.
Check the tool regularly on loose bolts/screws or parts.
In case of power loss: have the tool repaired.
Only trained and qualified engineers are allowed to adjust or repair the tool.
1 pcs bike adapter, 1pcs ball needle, 1pcs universal needle for inflating devices
Documents / Resources
| ABAC
G-813 6pcs Tool
Kit
[pdf] Instruction Manual
G-813, G-813 6pcs Tool Kit, 6pcs Tool Kit, Tool Kit, Kit
---|---