NUMERIC 2000 HR-V IBB Gaming Digital UPS User Guide

NUMERIC 2000 HR-V IBB Gaming Digital UPS

Product Specifications

• Model: 2000 HR-V IBB 28AH
• Input Voltage: 240 V AC
• Output Voltage: 240 V AC
• Capacity: 2 kVA
• Battery Type: Lithium-ion
• Manufacturer: New Energy to Power
• Website: www.numericups.com

Product Usage Instructions

Unboxing:
Cut the nylon belt and lift the carton box from the top. Remove the polythene cover, foams, and lift the UPS from the lower carton tray.

Installation:

1. Step 1: Turn on the battery circuit breaker.
2. Step 2: Connect the application input plug to the UPS output socket using a 3-pin 6A 240 V AC plug before switching the UPS on.
3. Step 3: Connect the UPS AC input power plug to a socket before switching the UPS on. Use a 3-pin 10A or 16A 240 V AC plug for 2 kVA.
4. Step 4: Press and hold the ON/Mute button on the front panel for 2 seconds to switch the UPS on.

LED Status:

• Green – AC Mode
• Yellow – Battery Mode
• Red – Fault

Do’s:

• Keep at least 30 cms clear distance between the rear panel of the UPS and the wall.
• Keep the UPS and its nearby area clean.
• Dry your hands before operating the UPS.

Don’ts:

• Do not eat or drink near the UPS area.
• Do not pull any wires connected to the UPS.
• Do not put fingers into any slot.

FAQ

• What should I do if the UPS displays a red LED status?
  The red LED indicates a fault. Check the connections and power source, and if the issue persists, contact customer support.

• Can I use a different type of plug for the UPS input?
  It is recommended to use a 3-pin 10A or 16A 240 V AC plug for the specified capacity of the UPS to ensure proper functionality and safety.

UNBOXING

Cut the nylon belt and lift the carton box from the top. Remove the polythene cover, foams and lift the UPS from the lower carton tray.

INSTALLATION

• Step 1
  Turn on the battery circuit breaker

• Step 2
  Connect the application input plug to the UPS output socket, use 3-pin 6A 240 V AC plug before switching the UPS on.

• Step 3
  Connect the UPS AC input power plug to socket before switching the UPS on (Use 3-pin 10A or 16A 240 V AC plug for 2 kVA.

• Step 4
  Press and Hold the ON/Mute button in the front panel for 2 seconds to switch the UPS on.

Display panel

1. Power Switch
2. LED

LED status

Do’s

• Keep at least 30 cms. clear distance between the rear panel of the UPS and the wall

• Keep the UPS and its nearby area clean

• Do dry your hands before operating the UPS.

Don’ts

• Do not eat or drink near the UPS area.

• Do not pull any wires connected to the UPS

• Do not put fingers into any slot

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>