The Home Depot 3095900 Single Handle Pull Down Sprayer Kitchen Faucet Instruction Manual
- June 1, 2024
- THE HOME DEPOT
Table of Contents
The Home Depot 3095900 Single Handle Pull Down Sprayer Kitchen Faucet
You may need
For easy installation of your faucet you will need:
- To READ ALL the instructions completely before beginning.
- To READ ALL warnings, care, and maintenance information.
Cleaning and Care
Care should be given to the cleaning of this product. Although its finish is extremely durable, It can be damaged by harsh abrasives or polish. To clean, simply wipe gently with a damp cloth and blot dry with a soft towel.
- As mandated by U.S. federal law , this showerhead is equipped with water flow regulator that limits maximum water flow to 1.8 GPM (6.8 liters) per minute at 80 psi water pressure .
- In areas with extremely low water pressure causing the shower water flow to be unsatisfactory, the flow regulator may be removed to improve the water flow in the shower head.
- Using screwdriver point or long nose pliers, pull out Water Regulator located inside Shower Handle.
- Come with a mini wrench is also attached in case you are lack of strenth to tighten.
- Additional silicone nozzle for future replacement.
Wiring Diagram
unit: inch (mm)
Installation
-
Install the thread pipe and connector as below. Apply teflon tape to al threads clockwise.
-
Install the assembled connector to the water outlet at wall. Install the fixing part with 4 piece of screws as picture shown.
-
Press the sliding holder button and move the sliding holder upward to remove it. Attention to the washer of the pipe, don’t lose the washer.
-
unscrew the screw on shower arm. Install the shower arm to the shower pipe, adjust the position accordingly and fasten the screw with an alien key.
-
Use #23 wrench to install the curved connecter to the downside of the diverter. No using teflon tape here.
-
Attach the wall cups to the diverter and shower arm seperately.
-
Unscrew the hexagon screw, install the shower pipe to the connector and fixing part, fasten the hexagon screw with an alien key.
-
Thread the Showerhead onto the Shower Arm. Tighten with #22 tool.
WARNING : DO NOT OVERTIGHTEN.
-
Screw hex nut with Hose Washer in place onto the bottom outlet of Diverter. Hand tighten connection
Screw the Conical nut with Hose Washer in place onto hand held shower. Hand tighten the connection. -
FLUSH SYSTEM/CHECK FOR LEAKS. Turn on hot and cold water supplies and flush water lines for one minute. Check all connections at arrows for leaks. Retighten if necessary, but do not overtighten.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>