ANKER A3330 soundcore C30i Open-Ear Earbuds User Guide
- June 1, 2024
- Anker
Table of Contents
ANKER A3330 soundcore C30i Open-Ear Earbuds
For FAQs and more support information, please visit:
Scan to View User Guide
WEARING
POWERING ON & PAIRING
TOUCH CONTROLS
24-month limited warranty
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong.
The following importer is the responsible party (contract for EU and UK
matters)
Anker Technology (UK) Limited
GNR8, 49 Clarendon Road, Watford, Hertfordshire, WD17 1HP, United Kingdom
Anker Innovations Deutschland GmbH
Georg-Muche-Strasse 3, 80807 Munich, Germany
- Input: 5V 0.6A
- Output: 5V 0.25A (0.125A per port)
- FCC ID: 2AOKB-A3330 220-JP7014
Important Safety Instructions
- Do not disassemble.
- Keep out of the reach of children. The product contains small parts which may be a choking hazard.
- The battery shall not be exposed to excessive heat such as sunshine, fire or the like.
- Do not use the product in environments with too high or too low temperatures, and never expose the product to strong sunshine or very wet environments.
- Ensure there is no liquid, sweat or water on the charging port when charging.
- Refer to your user manual for your earphones’ waterproof level and follow the corresponding instructions.
- For IPX4: Do not expose earphones to dripping or splashing water.
- For IPX4, IPX5, and IPX6: Do not submerge earphones in water.
Hearing Safety
- To avoid hearing damage, do not listen for extended periods at high volume.
- Do not turn the volume so high that you’re unable to hear your surroundings.
- Do not use earphones while driving.
- You should use caution or temporarily discontinue use in potentially hazardous situations.
The product generates stronger permanent magnetic fields that could cause interference with cardiac pacemakers, implanted defibrillators (ICDs) and other implants. Always maintain a distance of at least 3.94″/10 cm between the product component containing the magnet (earbuds and charging case) and the cardiac pacemaker, implanted defibrillator, or another implant.
Notice
This product complies with the radio interference requirements of the European
Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this product complies with
Directive 2014/53/EU. The full text of the EU Declaration of Conformity is
available at the following internet
address: https://www.soundcore.com.
Maximum output power: 9.0dBm
Frequency band: 2.4G band (2.402GHz-2.480GHz)
This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Follow local rules and never dispose of the product and rechargeable batteries with normal household waste. Correct disposal of old products and rechargeable batteries helps prevent negative consequences for the environment and human health.
This symbol indicates a “separate collection” for all batteries and accumulators. The a danger of explosion if the battery is incorrectly replaced. To reduce the risk of fire, explosion or leakage of flammable liquid/ gas, don’t disassemble, crush, puncture, short external contacts, expose to temperatures above 60°C (140°F), sunshine-like, or exposure to extremely low air pressure or disposed of in fire or water. Replace only with specified batteries. High or low extreme temperatures that a battery can be subjected to during use, storage or transportation:
- During use: maximum 40℃ (104°F)
- Storage: -20 – 45℃ (-4 – 113°F)
- Transportation: 5 – 35℃ (41 – 95°F)
FCC Statement
This product complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) the device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, under Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used by the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
The highest SAR value reported under this standard during product
certification for use next to the head with the minimum separation distance of
0mm. This transmitter must not be collocated or operating in conjunction with
any other antenna or transmitter.
The following importer is the responsible party. Company Name: Fantasia
Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: +1 (800) 988 7973
IC NOTICE TO CANADIAN USERS
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
(Cet appareil numérique de la Classe B conforme à la norme NMB-003 du Canada).
Radiation Exposure Statement
This EUT is in compliance with SAR for general population/uncontrolled
exposure limits in IC RSS-102 and has been tested by the measurement methods
and procedures specified in IEEE 1528 and IEC 62209. This equipment should be
installed and operated with a minimum distance of 0mm between the radiator and
your head. This device and its antenna(s) must not be co-located or operating
in conjunction with any other antenna or transmitter.