VOLLRATH 3873260W Cafeteria Breath Guard Installation Guide
- June 1, 2024
- VOLLRATH
Table of Contents
VOLLRATH 3873260W Cafeteria Breath Guard
INSTALLATION GUIDE
These instructions cover the installation of the one pice Cafeteria Breath Guard and the three piece Cafeteria Breath Guard.
One Piece Breath Guard installatiOn
Some units are shipped with a breath guard not installed. To install the breath guard follow these steps:
NOTE:
Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.
1. Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figure 1. Repeat for all four uprights.
Figure 1. One Piece Breath Guard Installation
2. Install the breath guard support tube (D) between the uprights (A)
securing with cap nuts (C) as shown. Repeat on the other side.
3. Install the one piece breath guard (E) securing with screws (F) and cap
nuts (C) as shown. Repeat for all four mounting locations.
4. Install the side breath protector (G) to the support tube (D) securing
with cap nuts (C) as shown. Repeat on the other side.
Three Piece Breath Guard installatiOn
Some units are shipped with a breath guard not installed. To install the breath guard follow these steps:
NOTE:
Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.
1. Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figures 1 and 2. Repeat for all four uprights.
Figure 2. Three Piece Breath Guard Installation
2. Install the breath guard support tube (D) between the uprights (A)
securing with cap nuts (C) as shown. Repeat on the other side.
3. Install the side breath guards (E) securing with screws (F) and cap nuts
(C) as shown. Repeat for all mounting locations.
4. Install the side shield (G) to the support tube (D) securing with cap nuts
(C) as shown. Repeat on the other side.
5. Install the support bar and stud assembly (H) to the side breath guards
(E). Repeat for all mounting locations.
6. Install the top breath guard (I) to the support bar and stud assembly (H)
securing with cap nuts (C). Repeat for all mounting locations.
The Vollrath Company, L.L.C.
1236 North 18th Street
Sheboygan, WI 53081-3201
U.S.A.
Main Tel: 800.628.0830
Service Tel: 800.628.0832
FAX: 800.752.5620
Vollrath of Canada, Co.
Tel: 800.695.8560
FAX: 800.752.5620
© 2010 The Vollrath Company, L.L.C.
Specifications:
-
Product Name: Cafeteria Breath Guard
-
Model: One Piece and Three Piece options available
-
Manufacturer: Vollrath Company, L.L.C.
-
Item No.: 2350030-01
-
-
FAQ
Q: What should I do if I accidentally over tighten the cap nuts?
A: If you accidentally over tighten the cap nuts and notice cracking, stop immediately and contact customer service for assistance.
Q: Can the breath guard be easily removed for cleaning?
A: Yes, the breath guard can be removed for cleaning by following the installation steps in reverse order. Make sure to clean all components thoroughly before reassembly.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>