NEUTRIK BDA 648 V1 etherCON Magnetics Instruction Manual
- May 21, 2024
- NEUTRIK
Table of Contents
BDA 648 V1 etherCON Magnetics
Product Information
The product is a receptacle designed to be installed in built-in electronic devices. It is not intended for use in PoE systems or explosive environments. The product is to be fastened with a special Neutrik A-screw, with a maximum torque of 40 Ncm.
For more details about the connectors, visit www.neutrik.com. The product is manufactured by Neutrik AG, with offices in various countries including the USA, UK, Germany, France, Japan, and Hong Kong.
Product Usage Instructions
- Install the receptacle in the panel cutout.
- Use the special Neutrik A-screw to fasten the product with a maximum torque of 40 Ncm.
- Finish the installation and fasten the screws.
It’s important to note that this product should not be used in PoE systems or explosive environments.
ASSEMBLY & SAFETY INSTRUCTION
etherCON® Magnetics I A & B-Series
NOTE:
- Attention: this Product is strictly not intended for use in PoE systems.
- This product is designed to be installed built-in electronic devices.
- This is product is strictly not intended to be used within explosive environments.
Assembly
- A. Install the receptacle in the panel cutout.
- B. Finish the installation and fasten the screws.
- Use the special Neutrik A-screw to fixing. max.
- Torque 40 Ncm.
Find more
details of connectors on www.neutrik.com.
Draft. Nr.: BDA 633 I Update: 2021-09-07 I Data subject to change without
prior notice. © 2021 NEUTRIK®. NEUTRIK® are registered trademark of Neutrik
AG. ALL RIGHTS RESERVED.
www.neutrik.com