The Home Depot BPS2430R Recessed Cabinet Instruction Manual
- June 1, 2024
- THE HOME DEPOT
Table of Contents
The Home Depot BPS2430R Recessed Cabinet
Product Information
- Specifications:
- Model Numbers: BPS2430R, BPS2430R-G, BPS2430R-N
- Includes: Medicine Cabinet x1, Shelf x2, Rubber plug screws x4, Mental screws x4
- Cabinet Dimensions:
- 24 in. (W) x 30 in. (H) x 5 in. (D)
- 22-4/5 in. (W) x 25-1/5 in. (H) x 3-4/5 in. (D)
- 21-3/5 in. (W) x 24 in. (H) x 3-1/2 in. (D)
Product Usage Instructions
- Installation for Recess-Mount Installations:
- Locate the desired installation area within the wall.
- Cut an opening in the wall to fit the dimensions of the cabinet.
- Insert the cabinet into the wall opening, ensuring it fits securely.
- Secure the cabinet in place using the provided rubber plug screws and metal screws.
FAQs
- Q: Can this medicine cabinet be surface-mounted instead of recessed?
- A: The design and installation instructions are specifically for recess-mount installations. Surface mounting may not be recommended.
- Q: What weight can the shelf hold?
- A: The shelf is designed to hold up to 10 lbs of weight distributed evenly.
List of Parts
Tools Needed
ROUGH WALL OPENING
Use a 1/4 in. (6 mm) drill bit for drywall anchor installation. Use a 1/8 in.
(3mm) drill bit for direct stud installation.
NOTE: If installing into a material other than drywall or into stud,
consult a professional for proper installation.
INSTRUCTIONS FOR RECESS-MOUNT INSTALLATIONS
INSTALLATION of CABINET
- Carefully remove all packing material. Place shelves and hardware aside until needed.
- Determine the desired location of the cabinet on the wall. Mark will to show the wall opening size. Generally, the recommended height to the centre of the cabinet is 64″ from the floor. Fig. 1
- CAUTION: Wall studs, plumbing or electrical lines that interfere must be removed or relocated. Cut the wall opening, being careful not to damage the surrounding wall surface. Insert framing to support all plasterboard edges
- Insert cabinet into wall opening in plumb and centred position. Use a carpenter’s level and shim corners of the cabinet if necessary.
- Once the cabinet is inserted into the wall, measure down 4″ from the top and the bottom of the cabinet. Centre the measurement on the sides of the cabinet. Fig 2.
- Using a drill bit, drill a total of 4 pilot holes in the locations determined in Step 5. Secure to wall studs through the 4 mounting holes inside the cabinet (screws provided)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>