blue built BBWMSE100B Wall Mount for Sonos Instruction Manual
- June 1, 2024
- blue built
Table of Contents
blue built BBWMSE100B Wall Mount for Sonos
INSTALL SPEAKER STAND
On a high note
In the box
-
Wall mount
-
Speaker stand
-
Mounting plate
-
Screws
-
Plugs
-
Screws
-
Zip tie velcro
From your own toolbox**** -
Cross-head screwdrivers
-
Pencil
-
Spirit level
-
Drill
CHECKLIST
Does the tick.
- Suitable surfaces:
- Wood
- Drywall
- Concrete
- Brick
Do you have a question?
Coolblue.nl/en/customer-service
Coolblue isn’t liable for any injury, damage, or arguments with your partner caused by a wrong installation. Not sure if you can do this yourself? Ask a professional installer.
INSTALLATION
-
STEP 1. Attach the base plate.
Place the mounting plate 3 on the speaker stand 2 and tighten the screws. -
STEP 2. Place the speaker.
Place the speaker on the mounting plate 3 and tighten the screws at the bottom. Feed the cable through the hole in the mount. -
STEP 3. Mark height.
With the spirit level, measure the height of the wall mount 1 . Make sure that the mount is straight. Mark the drill holes with the pencil. -
STEP 4. Drill holes.
Wooden wall: drill a 3.5mm wide and 50mm deep hole and screw the wall mount 1 with the screws to the wall.
Stonewall: drill an 8mm wide and 50mm deep hole. Place the plugs 5 around the screws 4 and screw the wall mount 1 to the wall. -
STEP 5. Attach the speaker.
Attach the speaker stand 2 to the wall mount 1 and optionally store away the cables with the zip tie 7 . -
STEP 6. Adjust the speaker.
Tilt the speaker upwards or downwards or move it to the left and right. This way, you can adjust the sound to your liking.
BlueBuilt is a registered trademark of Coolbue B.V., Weena 664, 3012 CN Rotterdam, The Netherlands.