PLP Battery Supply 697200 120 Minute Electromechanical Timer User Manual
- June 1, 2024
- PLP Battery Supply
Table of Contents
POWER FORGED™
Battery Charger Service Parts
PLP BATTERY SUPPLY
Murphysboro, IL 62966
800-642-3451
697200 120 Minute Electromechanical Timer
697200 120-Minute Electromechanical Timer ONLY – Screw Mount
120-Minute Electromechanical Timer w/ Hold, 120 VAC – Screw mount. Replaces
Associated 611245.
Contents:
1 – 697200, 120-minute timer – screw mount
2 – 609052, mounting screws
1 – instruction sheet
Back of Timer with Terminal Labels
This timer replaces the 611245 timer found in Associated Equipment battery
chargers. This is an exact OEM replacement part.
This timer can also be retrofitted in other chargers to replace obsolete
electromechanical timers.
NOTE: NO timer dial labels or knobs are included with this part. Timer
Terminal Connections
There are 3 push-on, ¼” terminals and 1 loose wire for the electrical
connections to this timer.
697200-697201 Circuit Function Timer Circuit Function
Terminal 5 and the loose wire are the AC input required to run the timer,
usually from the AC power cord.
Terminal 4 is the AC output to supply the charger with power – usually sending
the timer-controlled AC current to the transformer or rate select switch.
Current flows when the timer is in an “ON” position –either while counting
down or in the HOLD position.
Terminal 6 is not used. Panel Mounting Instructions
If it is necessary to drill or punch holes to mount the timer, the template at
left may be used to mark the cabinet for drilling or punching. The panel will
need three holes, in accordance with the diagram. The timer knob stem fits
through the center hole, and the smaller holes accept the mounting screws.
(Dial label 609063 is used for this horizontal screw configuration.
Order separately, or in kit 697202.)
If the mounting screw holes are vertically aligned, rotate the template 90
degrees counter-clockwise. This places the OFF position at approximately 11
o’clock from the stem.
(Dial label 609064 is used for the vertical screw configuration. Order
separately, or in kit 697202.)
Installation & Wiring
Examples for Various Associated Chargers 
Questions?
We are here to help.
► Call us: 800-642-3451
or email: info@plpbattery.com
697200 Installation Sheet.pdf
© 2024, PLP Battery Supply
Rev 04/2024
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>