BRAYER BR2001 Electric Grill Press Instruction Manual

brayer.su

Instruction manual

Electric grill press BR2001

PRESS GRILL BR2001

The grill is used for cooking meat, fish or vegetables. The unit can be used as a press grill or a flat frying surface.

ATTENTION!
For additional protection it is reasonable to install a residual current device (RCD) with nominal operation current not exceeding 30 mA into the mains. To install RCD, contact a specialist.

DESCRIPTION

1. Support legs
2. Temperature control knob «1-2-3-4-5»
3. Lower part of the grill
4. Lower frying plate
5. Upper frying plate
6. Upper part of the grill
7. Handle
8. Upper plate lock button
9. Upper and lower parts’ lock/Regulator of clearance between the frying plates « / I-II-II-IV-V»
10. Grill opening button «180»
11. Light indicators
12. Lower plate lock button
13. Operation mode switch «open grill — OFF — closed grill  »
14. Tray

SAFETY MEASURES AND OPERATION RECOMMENDATIONS

Read the operation manual carefully before using the press grill; after reading, keep it for future reference.

• Use the press grill for its intended purpose only, as specified in this manual.
• Mishandling the grill can lead to its breakage and cause harm to the user or damage to the user’s property, which is not covered by warranty.
• Make sure that the operating voltage of the unit indicated on the label corresponds to your home mains voltage.
• Connect the power plug to the socket with reliable grounding contact.
• To avoid fire, do not use adapters for plugging the press grill in.
• Install and use the press grill on a flat, dry, steady and heat-resistant surface with free access to the mains socket.
• Do not use the unit outdoors.
• It is recommended not to use the unit during lightning storms.
• Protect the grill from impacts, falling, vibrations and other mechanical stress.
• Never leave the unit connected to the mains unattended.
• Do not use the unit near heating appliances, heat sources or open flame.
• Do not use the grill in places where aerosols are used or sprayed, and in proximity to inflammable liquids.
• Do not use the grill in proximity to the kitchen sink, in bathrooms, near swimming pools or other containers filled with water.
• If the grill is dropped into water, unplug it immediately, and only then you can take the unit out of water.
• Do not let the power cord touch hot surfaces and sharp edges of furniture.
• The press grill body heats up strongly during operation, do not touch hot surfaces marked with «» to avoid burns.
• Do not move the press grill when it is hot; wait until it cools down completely.
• Use the unit in places with proper ventilation.
• Use only the removable parts supplied with the press grill.
• Do not switch the press grill on without products.
• Do not use the grill for cooking frozen food,
• defrost frozen food before cooking.
• Beware of steam output from the gaps between the operating surfaces, do not touch and do not place open parts of your body near the gaps between the frying plates.
• Take the products out of the press grill right after cooking; keeping products in the operating grill for a long time can cause their ignition.
• Never use metal objects to take the cooked food out, as they can damage the non-stick coating of the frying plates; use the kitchen tools intended for nonstick surfaces.
• Unplug the unit after usage or before cleaning. When unplugging the grill, hold the power plug and carefully remove it from the mains socket, do not pull the power cord, as this can lead to its damage and cause a short circuit.
• Do not touch the unit body, the power cord and the power plug with wet hands.
• For child safety reasons do not leave polyethylene bags used as packaging unattended.

ATTENTION!
Do not allow children to play with polyethylene bags or packaging film. Danger of suffocation!

• The unit is not intended for usage by children.
• Do not leave children unattended to prevent using the unit as a toy.
• Do not allow children to touch the operating surface, the unit body, the power cord or the power plug during operation of the unit.
• Be especially careful if children or disabled persons are near the operating unit.
• During the unit operation and breaks between operation cycles, place the unit out of reach of children.
• The unit is not intended for usage by physically or mentally disabled persons (including children) or by persons lacking experience or knowledge if they are not under supervision of a person who is responsible for their safety or if they are not instructed by this person on the usage of the unit.
• From time to time check the power cord integrity.
• If the power cord is damaged, it should be replaced by the manufacturer, a maintenance service or similar qualified personnel to avoid danger.
• Do not repair the unit by yourself. Do not disassemble the unit by yourself, if any malfunction is detected, and after the unit was dropped, unplug it and apply to the authorized service center.
• To avoid damages, transport the unit in the original package.
• Keep the unit in a dry cool place out of reach of children and disabled persons.

THE UNIT IS INTENDED FOR HOUSEHOLD USE ONLY

BEFORE THE FIRST USE

After unit transportation or storage at negative temperature, unpack it and wait for 3 hours before using.

• Unpack the unit and remove all the packaging materials.

• Keep the original package.

• Check the delivery set.

• Read the safety measures and operating recommendations.

• Examine the unit for damages, in case of damage do not plug it into the mains.

• Make sure that specified specifications of power supply voltage of the unit correspond to the specifications of your mains. When the unit is powered from 60 Hz frequency mains, no additional actions are necessary.

• Clean the grill body surface with a slightly damp cloth and then wipe it dry.

• Move the lock (9) to the position « », take the handle (7) and open the grill.

• Remove the upper frying plate (5) by pressing on the lock (8) from the side.

• Remove the lower frying plate (4) by pressing on the lock (12).

• Remove the tray (14).

• Wash the frying plates (4, 5) and the tray (14) with warm water and neutral detergent, rinse them and wipe dry.

• Install the grids (4, 5) back to their places, to do this, match the ledges on the unit body with the grooves in the lower part of the plates (4, 5) and then lift the upper plate (5) and move down the lower plate (4) until the locks (8, 12) clicking. Make sure that the plates (4, 5) are fixed.

• Note: — the plates (4, 5) are two sided, they can be used both as a press grill and a flat frying surface.

• Place the grill keeping at least a 20 cm gap between the grill body and the walls and 50 cm of space above the grill.

• Use the grill on a flat steady surface, away from sources of moisture,

• heat and open flame with free access to the mains socket.

• Do not place and do not use the grill near highly inflammable objects

• or liquids and objects subject to thermal deformation.

• Use the unit in places with proper ventilation.

• Make sure that the tray (14) is installed to its place.

• Before using the grill open it and oil the frying plates (4, 5) slightly.

• Insert the power plug into the mains socket.

• Set the temperature control knob (2) to the position «5».

• Turn the operation mode switch (13) knob clockwise and set it to the position «closed grill — », )», the light indicator (11) in the knob will light up.

• Notes:
  – when the grill is switched on, the light indicator in the operation mode switch (13) knob will glow constantly;
  – the light indicator in the temperature control knob (2) will light up when the frying plates (4, 5) reach the preset temperature. The indicator will go out and light up again showing that the frying plates (4, 5) temperature is maintained.

• After approximately 5-7 minutes switch the grill off by setting the operation mode switch (13) knob to the position «OFF», unplug the grill and wait until it cools down completely. Take the handle (7), open the grill and remove the remaining vegetable oil from the frying plates (4, 5) with a paper towel.

• The grill is ready to use.

• Notes:
  – when using the unit for the first time, a foreign smell or some smoke from the heating elements can appear — this is normal and it is not covered by warranty.

FOOD COOKING WITH THE GRILL

• ATTENTION!
  – The press grill body heats up strongly during operation, do not touch hot surfaces marked with « » to avoid burns.
  – Beware of steam output from the gaps between the operating surfaces, do not touch and do not place open parts of your body near the gaps between the frying plates.
  – Do not use the grill for cooking frozen food.
  – Do not cook meat with large bones.
  – Frying time depends on the products used.
  – Before using the grill make sure that the tray (14) is installed to its place.
  – Do not open the grill after switching it on, the frying plates (4, 5) heat up faster and more even in the closed position.
  – Before eating make sure that the food is cooked through.
  – Take the products out of the press grill right after cooking; keeping products in the operating grill for a long time can cause their ignition.
  – Never use metal objects to take the cooked food out, as they can damage the non-stick coating of the frying plates (4, 5); use the kitchen tools intended for non-stick surfaces.

• Prepare the necessary products.

• Insert the power plug into the mains socket.

• Set the temperature control knob (2) to the required position:
  «1» — minimal heating temperature of the frying plates (4, 5);
  «5» — maximal heating temperature of the frying plates (4, 5).

• Turn the operation mode switch (13) knob clockwise and set it to the position «closed grill — », the light indicator (11) in the knob will light up.

• Wait until the frying plates (4, 5) heat up and the indicator (11) lights up in the temperature control knob (2).

• Take the handle (7) and open the grill.

• Carefully put the products on the lower frying plate (4), avoid burns by possible splashes of juice or fat dripping from the products.

• Take the handle (7) and lower the upper frying plate (5) on the products.

• Note: — depending on the thickness of the cooked products you can adjust the clearance between the frying plates (4). To do this, move the lock (9) handle to the required position «I-II-II-IV-V».

• After you finish cooking, take the handle (7) and lift the upper frying plate (5).

• Put the prepared products into an appropriate dish; use wooden or heat-resistant plastic kitchen tools to remove the products.

• To switch the grill off turn the operation move switch (13) and set it to the position «OFF», the light indicators (11) will go out. Then unplug the unit.

USING THE GRILL AS A COOKING UNIT

• You can use the grill as a flat frying surface.
• Before connecting the power plug to the mains socket open the grill. To do this, take the handle (7) and lift the upper part of the grill (6).
• Press the button (10) «180» and open the grill completely.
• Install the frying plates (4, 5) with the necessary side (grill/flat surface).
• Insert the power plug into the mains socket.
• Set the temperature control knob (2) to the required position «1-5».
• Turn the operation mode switch (13) knob counterclockwise and set it to the position «open grill — », the light indicator (11) in the knob will light up.
• Wait until the frying plates (4, 5) heat up and the indicator (11) lights up in the temperature control knob (2).
• Carefully put the products on the frying plates (4, 5), avoid burns by possible splashes of juice or fat dripping from the products.
• Put the prepared products into an appropriate dish; use wooden or heat-resistant plastic kitchen tools to remove the products.
• To switch the grill off set the operation move switch (13) knob to the position «OFF», the light indicators (11) will go out. Then unplug the unit.
• Wait until the grill cools down completely, then lift the upper part of the grill (6) and fold the upper (6) and the lower (3) parts together.
• To fix the lower (3) and the upper (6) parts of the grill set the lock (9) handle to the position « ».

CLEANING AND CARE

• Clean the frying plates (4, 5) of the grill after every use.
• Switch the grill off by setting the operation mode switch (13) knob to the position «OFF», unplug it and wait until the press grill cools down completely.
• Clean the grill body surface with a slightly damp cloth and then wipe it dry.
• Take the handle (7) and open the grill.
• Remove the upper frying plate (5) by pressing on the lock (8) on the side.
• Remove the lower frying plate (4) by pressing on the lock (12).
• Remove the tray (14) and pour the liquid out of it.
• Wash the frying plates (4, 5) and the tray (14) with warm water and neutral detergent, rinse them and wipe dry.
• Install the grids (4, 5) back to their places, to do this, match the ledges on the unit body with the grooves in the lower part of the plates (4, 5) and then lift the upper plate (5) and move down the lower plate (4) until the locks (8, 12) clicking. Make sure that the plates (4, 5) are fixed.
• Do not use metal brushes, abrasives or solvents to clean the frying plates (4, 5) and the grill body.
• Do not immerse the grill, the power cord and the power plug into water or any other liquids.

STORAGE

• Before taking the grill away for storage, clean the frying plates (4, 5) and the grill body.
• Press together the lower (3) and the upper (6) parts of the grill and set the lock (9) handle to the position
•  « ».
• Keep the unit in a dry cool place out of reach of children and disabled persons.

DELIVERY SET

1. Press grill — 1 pc.
2. Frying plates — 2 pcs.
3. Tray — 1 pcs.
4. Manual — 1 pc.

TECHNICAL SPECIFICATIONS

• Power supply: 220-240 V, ~ 50-60 Hz
• Rated input power: 2000 W

RECYCLING

To prevent possible damage to the environment or harm to the health of people by uncontrolled waste disposal, after service life expiration of the unit or the batteries (if included), do not discard them with usual household waste, deliver the unit and the batteries to specialized centers for further recycling.

The waste generated during the disposal of the unit is subject to mandatory collection and consequent disposal in the prescribed manner.

For further information about recycling of this product apply to a local municipal administration, a disposal service or to the shop where you purchased this product.

The manufacturer reserves the right to change the appearance, design and specifications not affecting general operation principles of the unit, without prior notice.

The unit operating life is 3 years

The manufacturing date is specified in the serial number.

In case of any malfunctions promptly apply to the authorized service center.

Hergestellt für «Ruste GmbH»,
Berggasse 18/18, 1090 Wien,
Osterreich
Produced for «Ruste GmbH»,
Berggasse 18/18, 1090 Vienna, Austria
т.: +7 (495) 297-50-20,
e-mail: info@brayer.su

Made in China

brayer.su

https://tm.by

References

• BRAYER - официальный сайт австрийского бренда бытовой техники

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>