CHAMBERLAIN MYQ-G0301 Smart Garage Hub User Guide
- June 14, 2024
- CHAMBERLAIN
Table of Contents
CHAMBERLAIN MYQ-G0301 Smart Garage Hub
WHAT’S IN THE BOX
BEFORE YOU START
Read all warnings and instructions below thoroughly BEFORE beginning. You will need:
- Access to your compatible garage door opener.
- A 2.4 GHz router with a strong Wi-Fi® signal inside your garage.
- Your Wi-Fi password.
- Your mobile device connected to your Wi-Fi network (not cellular).
- Bluetooth® enabled on your mobile device.
- A drill with 5/32” bit, screwdriver and ladder (optional).
LET’S GET SET UP
Download the free myQ® App. Follow the in-app instructions to set up the Smart Garage Control.
Available on most iOS and Android Devices.
WHEN YOU ARE SET UP
Download the Smart Garage Control Owner’s Manual.
Replacement Parts
041-0106….Smart Garage Control Power Supply
MYQ-G0402……Chamberlain Door Sensor
K010A0056……..Door Sensor 3V Battery, CR2450
ADDITIONAL INFORMATION
To reduce the risk of SEVERE INJURY to persons:
- DO NOT enable the Chamberlain Smart Garage Control if operating either one-piece or swinging doors. Enable this device with sectional doors ONLY.
Within the US: The Smart Garage Control is not intended for use with garage door openers in which the photoelectric sensors located near the bottom of the garage door change power mode (e.g., lights on the sensors turn off after the door is closed), or any Chamberlain Group opener with a yellow learn button manufactured between 2010 and 2021, or any Linear opener.
WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
One Year Limited Warranty
The Chamberlain Group LLC warrants to the first consumer purchaser of this product that it is free from defect in materials and/or workmanship for a period of 1 year from the date of purchase.
Software Agreement
Product and the software contained herein are copyrighted. Your opening and
use constitutes acceptance of, and is subject to, License Agreement and Terms
of Use available at www.myq.com/agreement
NOTICE: This device complies with Part 15 of the FCC rules and Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device must be installed to ensure a minimum 20 cm (8 in.) distance is
maintained between users/bystanders and device.
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules and Industry Canada ICES
standard.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>