JETSON 3AA Wheel Light Up Kick Scooter Instruction Manual
- June 14, 2024
- Jetson
Table of Contents
JETSON 3AA Wheel Light-Up Kick Scooter
IMPORTANT
READ CAREFULLY AND RETAIN FOR FUTURE REFERENCE.
Safety Warnings
- Before use, please read the user manual and safety warnings carefully, and make sure you understand and accept all the safety instructions.
- The user will be responsible for any loss or damage caused by improper use.
- Before each cycle of operation, the operator shall perform the preoperation checks specified by the manufacturer: That all guards and pads originally supplied by the manufacturer are in proper place and in serviceable condition; That the braking system is functioning properly; That any axle guards, chain guards, or other covers or guards supplied by the manufacturer are in place and serviceable condition;
- The tires are in good condition, inflated properly, and have sufficient tread remaining; The area where the product is to be operated should be safe and suitable for safe operation.
- Components shall be maintained and repaired per the manufacturer’s specifications and using only the manufacturer’s authorized replacement parts with installation performed by dealers or other skilled persons.
- Warning against recharging non-rechargeable batteries.
- Don’t allow hands, feet, hair, body parts, clothing, or similar articles to come in contact with moving parts, wheels, or drive train, while the motor is running.
- This product should not be used by children or persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction (IEC 60335-1/A2:2006).
- Unsupervised children should not play with the product (IEC 60335-1/A2:2006).
- Adult supervision is required.
- The rider should not exceed 110 lb.
- Units shall not be operated to perform racing, stunt riding, or other maneuvers, which may cause loss of control or may cause uncontrolled operator/passenger actions or reactions.
- Never use near motor vehicles.
- Avoid sharp bumps, drainage grates, and sudden surface changes. The scooter may suddenly stop.
- Avoid streets and surfaces with water, sand, gravel, dirt, leaves, and other debris. Wet weather impairs traction, braking, and visibility.
- Avoid riding around flammable gas, steam, liquid, or dust that could cause a fire.
- Operators shall adhere to all of the manufacturer’s recommendations and instructions, as well as comply with all laws and ordinances: Units without headlights shall be operated only with adequate daylight conditions of visibility, and; Owners shall be encouraged to highlight (for conspicuity) using lighting, reflectors, and for low-riding units, signal flags on flexible poles.
- Persons with the following conditions shall be cautioned not to operate: Those with heart conditions; Pregnant women; Persons with head, back, or neck ailments, or prior surgeries to those areas of the body; and persons with any mental or physical conditions that may make them susceptible to injury or impair their physical dexterity or mental capabilities to recognize, understand, and perform all of the safety instructions and to be able to assume the hazards inherent in unit use.
- Do not ride at night.
- Do not ride after drinking or taking prescription medication.
- Do not carry items when riding.
- Never operate the product barefoot.
- Always wear shoes and keep shoelaces tied.
- Make sure your feet are always placed securely on the deck.
- Operators always shall use appropriate protective clothing, including but not limited to a helmet, with appropriate certification, and any other equipment recommended by the manufacturer: Always wear protective equipment such as a helmet, knee pads, and elbow pads.
- Always give way to pedestrians.
- Be alert to things in front and far away from you.
- Do not allow distractions when riding, such as answering the phone or engaging in any other activities.
- The product cannot be ridden by more than one person.
- When you ride the product along with other riders, always keep a safe distance to avoid a collision.
- When turning, be sure to maintain your balance.
- Riding with improperly adjusted brakes is dangerous and can result in serious injury or death.
- The brake may become hot while operating, do not touch the brake with your bare skin.
- Applying brakes too hard or too suddenly can lock up a wheel, which could cause you to lose control and fall. Sudden or excessive application of the brake may result in injury or death.
- If the brake loosens, please adjust with the hexagon wrench, or please contact the Jetson Care Team.
- Replace worn or broken parts immediately.
- Check whether all safety labels are in place and understood before riding.
- The owner shall allow the use and operation of the unit after a demonstration so that such operators can understand and operate all components of the unit before use.
- Do not ride without proper training. Do not ride at high speeds, on uneven terrain, or slopes. Do not perform stunts or turn abruptly.
- Recommended for indoor use.
- Prolonged exposure to UV rays, rain, and the elements may damage the enclosure materials, stored indoors when not in use.
California Proposition 65
WARNING
This product can expose you to chemicals including Cadmium, which is known
to the State of California to cause cancer and birth defects or other
reproductive harm. For more information go to: www.P65Warnings.ca.gov.
MODIFICATIONS
Do not attempt to disassemble, modify, repair, or replace the unit or any
components of the unit without instruction from the Jetson Care Team. This
will void any warranty and can lead to malfunctions which may cause injury.
ADDITIONAL OPERATION PRECAUTIONS
Do not lift the product off the ground while it is on and the wheels are in
motion. This can result in freely spinning wheels, which may cause injury to
yourself or others nearby. Do not jump on or off the product, and do not jump
while using it. Always keep your feet firmly planted on the footrest while in
operation. Always check the battery charge before using.
NOTICE OF COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Warning: Changes or
modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
DISPOSAL OF USED BATTERY
The battery may contain hazardous substances which could endanger the environment and human health. This symbol marked on the battery and/or packaging indicates that the used battery shall not be treated as municipal waste. Batteries should be disposed of at an appropriate collection point for recycling. By ensuring the used batteries are disposed of correctly, you will help prevent potential negative consequences for the environment and human health. The recycling of materials will help to conserve natural resources. For more information about recycling used batteries, please contact your local municipality waste disposal service.
Specs & Features SPECS
- WHEEL SIZES: 4.7 IN (FRONT), 3.5 IN (REAR)
- UNFOLDED DIMS: 23 IN (L) × 11.3 IN (W) × 23.1 IN (H)
- FOLDED DIMS: 23.3 IN (L) × 11.3 IN (W) × 5.8 IN (H)
- DECK SIZE: 22.5 IN (L) × 5.6 IN (W)
- HANDLEBAR HEIGHT: 24.5 IN – 30.8 IN
- WEIGHT LIMIT: 110 LBS
- PRODUCT WEIGHT: 7 LBS
- RECOMMENDED AGE: 3+
- BATTERIES REQUIRED: 3 AA
FEATURES
- REAR FOOT BRAKE
- LED LIGHT-UP WHEELS & STEM
- EASY FOLDING TECHNOLOGY
Product Overview
- HANDLEBAR
- LIGHTING CONTROL BUTTON
- STEM CLAMP
- STEM (LED-LIGHT UP)
- STEM RELEASE FOLDING MECHANISM
- FRONT WHEEL (MOTION-ACTIVATED LED LIGHT-UP)
- BATTERY COMPARTMENT
- DECK
- REAR FOOT BRAKE
- REAR WHEEL (MOTION-ACTIVATED LED LIGHT-UP)
TOOL INCLUDED
2-BIT PHILLIPS-HEAD SCREWDRIVER AND ALLEN KEY TOOL
NOTE: IMAGES MAY NOT REFLECT THE EXACT APPEARANCE OF THE ACTUAL PRODUCT.
Getting Started
Unfolding/Folding Your Scooter
- TO UNFOLD OR FOLD, FIRST PULL THE STEM RELEASE FOLDING MECHANISM UP TOWARDS THE HANDLEBAR.
- TO UNFOLD: WHILE PULLING THE STEM RELEASE UPWARD, RAISE THE STEM TO AN UPRIGHT POSITION UNTIL IT CLICKS INTO PLACE.
- TO FOLD: PULL THE STEM RELEASE UPWARD AND LOWER THE STEM DOWN TOWARDS THE DECK UNTIL IT CLICKS INTO PLACE.
Adjusting the Handlebar
- USING THE ALLEN KEY TIP OF THE 2-BIT TOOL, LOOSEN THE KNOB.
- OPEN THE STEM CLAMP LEVER.
- PRESS IN THE STEM PIN AND RAISE OR LOWER THE HANDLEBAR UNTIL THE PIN CLICKS INTO ANOTHER STEM PINHOLE.
- CLOSE THE STEM CLAMP LEVER AND TIGHTEN THE KNOB TO SECURE THE HANDLEBAR IN PLACE.
IMPORTANT: THE STEM PIN ALONE WILL NOT KEEP THE STEM SECURE. MAKE SURE THE STEM CLAMP IS TIGHTENED AND CLOSED BEFORE RIDING.
Inserting the Batteries
- USE THE SCREWDRIVER TIP OF THE 2-BIT TOOL TO REMOVE THE BATTERY COMPARTMENT COVER.
- INSERT 3 AA BATTERIES ACCORDING TO THE +/- DIRECTIONS INDICATED IN THE COMPARTMENT.
- REPLACE THE BATTERY COMPARTMENT COVER AND TIGHTEN THE SCREW WITH THE SCREWDRIVER.
Using the Brake
PRESS DOWN GENTLY WITH YOUR REAR RIDING FOOT TO SLOW DOWN. APPLY MORE PRESSURE
TO COME TO A COMPLETE STOP.
Making Moves
**Riding Your Scooter
**
- PLACE ONE FOOT ON THE FRONT OF THE DECK FACING FORWARD.
- PUSH THE OTHER FOOT OFF THE GROUND TO PROPEL THE SCOOTER FORWARD. REPEAT AS NECESSARY TO ACHIEVE OR MAINTAIN THE DESIRED SPEED.
- TO COAST, PLACE KICKING FOOT ON THE REAR OF THE DECK, TURNED OUTWARD AT A SLIGHT ANGLE FOR STABILITY. THE STAR IS A LEAN-TO-STEER SCOOTER. TO TURN, SLIGHTLY LEAN LEFT OR RIGHT WHILE RIDING AND THE SCOOTER WILL VEER ACCORDINGLY.
Activating the LED Lights
LED LIGHT FUNCTIONS:
- TO TURN THE STEM LED LIGHTS ON, QUICK-PRESS THE LIGHTING CONTROL BUTTON ON THE HANDLEBAR.
- QUICK-PRESS THE BUTTON AGAIN TO CYCLE THROUGH 20 DIFFERENT LIGHTING STYLES. STOP PRESSING TO KEEP THE LIGHTS IN A SPECIFIC STYLE.
- TO TURN OFF THE LIGHTS, HOLD DOWN THE LIGHTING CONTROL BUTTON FOR 3 SECONDS.
LIGHTING NOTES
- THE WHITE LED LIGHTS ON THE FRONT AND REAR WHEELS WILL ILLUMINATE WHENEVER THE WHEELS ARE IN MOTION—EVEN IF THE STEM LIGHTS ARE NOT ON.
- THE STEM LIGHTS WILL SHUT OFF AFTER 5 MINUTES OF NO USE. TO RE-ACTIVATE, QUICK-PRESS THE LIGHTING CONTROL BUTTON.
- IMPORTANT : TO PRESERVE BATTERY POWER, REMEMBER TO TURN OFF THE LIGHTS WHEN YOU ARE FINISHED RIDING.
Helmet Safety
- PROPER POSITIONING: THE FOREHEAD IS COVERED BY THE HELMET.
- IMPROPER POSITIONING:
- THE FOREHEAD IS EXPOSED.
- A FALL COULD RESULT IN SERIOUS INJURY.
WEAR A HELMET, APPROPRIATE CLOTHING, SHOES, AND SAFETY GEAR. AVOID CLOTHING THAT CAN GET CAUGHT INTO OR UNDER THE WHEELS. CLOSED-TOE, FLAT SHOES ARE RECOMMENDED. WEAR AN ASTM F1492-APPROVED HELMET AND PROTECTIVE GEAR TO PREVENT INJURY IN THE EVENT OF AN ACCIDENT.
Care, Maintenance, & Warranty
CLEANING YOUR STAR
- TO CLEAN YOUR SCOOTER, CAREFULLY WIPE WITH A DAMP CLOTH AND THEN DRY WITH A DRY CLOTH.
- DO NOT APPLY WATER DIRECTLY TO THE SCOOTER. WATER CAN DAMAGE THE FRAME AND/OR ELECTRICAL COMPONENTS, WHICH CAN RESULT IN A MALFUNCTION THAT PUTS RIDER SAFETY AT RISK. MAINTAINING YOUR STAR
- KEEP AWAY FROM FIRE AND EXCESSIVE HEAT.
- AVOID INTENSE PHYSICAL IMPACT AND/OR SEVERE VIBRATION.
- RIDE THE SCOOTER ON A SMOOTH, FLAT SURFACE.
- PROTECT FROM WATER OR MOISTURE.
- CONTACT THE JETSON CARE TEAM IF THERE ARE ANY ISSUES WITH YOUR SCOOTER.
STORING YOUR STAR
- STORE YOUR SCOOTER INDOORS AND IN A DRY PLACE.
- COVER YOUR SCOOTER TO PROTECT IT AGAINST DUST.
ONE-YEAR GENERAL LIMITED WARRANTY
All new Jetson products, excluding parts and accessories, are warranted against defects in materials and workmanship for one year from the date of original retail purchase when used by Jetson’s user manuals (refer to ridejetson.com/support). Under this warranty, you will be able to direct your claims to Jetson even in situations where you purchased the Jetson Product from one of our authorized retailers. To read the full terms of our warranty, visit ridejetson.com/warranty.Stay connected. Be sure to follow ridejetson on social media to learn about fantastic offers, giveaways, and all the latest Jetson news.
Loving your ride?
Then be sure to leave a review at
ridejetson.com/reviews.
We can’t wait to hear from you!
Questions? Let us know.
ridejetson.com/support
ridejetson.com/chat
To exercise your product’s 1-year limited warranty or inquire about the
warranty coverage, contact us directly.
US/CANADA: 1-888-976-9904
MEX: +001 888 976 9904
UK: +44 (0)33 0838 2551
Manufactured in Yongkang, China
Imported by Jetson Electric Bikes LLC.
P.O. Box 320149, 775 4th Ave #2,
Brooklyn, NY 11232
www.ridejetson.com
2022, JETSON. ALL RIGHTS RESERVED. Manufactured by JETSON ELECTRIC BIKES LLC. No portion of this document, including shape, copy, graphics, and design, may be reproduced or transmitted in any form or by any means.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>