TEIA TTU-C40 Integrated Tool Tag User Manual
- June 28, 2024
- TEIA
Table of Contents
User Manual
Integrated Tool Tag
TTU-C40 (HAE-ST-UWB-E-N-P-005)
Introduction
– Product name: Integrated Tool Tag
– Model: TTU-C40 (HAE-ST-UWB-E-N-P-005)
– This device is designed to be attached to the object for tracking its
location in indoor environment
– The product broadcasts Ultra Wide-band signal and infrastructure calculates
the signal to determine its 0D(presence detection), 1D, 2D coordinates.
Figure 1 Product picture
Technical Specification
– Size: 57 x 40 x 18 mm – Weight: 41g – Features: Radio broadcasting for indoor location – Power Supply: Internal Li-Pol 900mAh battery (Wired charging, C-Type) – Radio: UWB 6.5GHz – Housing: Engineering plastic (PC) – Environment: Industrial / Warehouse – Operating conditions: -20 ~ 60, 20~85% Humidity without condensation
Parts Names and Features
Figure 2 Parts names
– Status LED:
: Blink or On Working / Off Battery discharge
: GREEN High level of battery / ORANGE Middle level of battery / RED Low
level of battery
How to Use
– Attach to the desired tracking object’s surface using attachment hole
– Check Status LED is GREEN blink or on, charge the battery if not.
Battery Charge
– Charge using C Type cable.
– Status LED is GREEN on when charging is completed.
Safety and Regulatory Information
– Please use the device in indoor environment only.
– Do nor use the device in wet conditions.
– Throwing or dropping the device above a certain height (2 meters) may cause
damage.
– If the device is wet, please remove the moisture with dry cloth.
– When the device is not working properly, do not disassemble the product and
contact the manufacturer.
Warning Statement
Any changes or modifications not expressly approved by the party responsible
for compliance could void the authority to operate equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation of the device.
This equipment complies with radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. End users must follow
the specific operating instructions for satisfying RF exposure compliance.
“This equipment may only be operated indoors. Operation outdoors is in
violation of 47 U.S.C. 301 and could subject the operator to serious legal
penalties.”
TEIA Co., Ltd.
Suite B-303/304, 33 Gwacheon-daero 7-gil
Gwacheon-si, Gyeonggi-do, Republic of Korea
Tel. 02.6390.6223 / Fax. 02.6390.6224
E-Mail: teia_sales@teia.co.kr