Ford RACING M-7210-FA Fiesta Short Throw Shifter Instruction Manual

Table of Contents

Specifications

Removal of Gearshift Lever

Set the parking brake.
Place the shifter in neutral.
Remove the shifter cover/heater control faceplate by gently pulling up on the rear of the cover/faceplate. It is retained by push-in clips.
Gently pull the shifter cover/faceplate straight back, freeing it from the dash around the heater controls. Disconnect any wires if necessary.
Remove console side panels #2 and #8 by removing the push pins at the front of the panels. Pull the rear of the panels to free the push-in clips. Set the panels aside.
Unscrew the shifter knob to remove the shifter boot. Lift the shifter boot at the base, freeing it from the console.
Remove console bolts #5 and #6. Unplug any electrical connectors at the front sides of the console. This allows you to shift the console back and lift the front of it to gain access to the shifter.
Remove the shifter cables from the shift levers and base.

Frequently Asked Questions (FAQ)

Q: Where can I find factory Ford shop manuals?
A: Factory Ford shop manuals are available from Helm Publications. You can contact them at 1-800-782-4356.
Q: What should I do if I don’t understand the instructions?
A: If you have any difficulties understanding the instructions, please call the Ford Racing Touchline at 1-800-367-3788 for assistance.

M-7210-FA
Ford Fiesta Short Throw Shifter INSTALLATION INSTRUCTIONS

NO PART OF THIS DOCUMENT MAY BE REPRODUCED WITHOUT PRIOR AGREEMENT AND WRITTEN PERMISSION OF FORD RACING PERFORMANCE PARTS.
Please visit www.fordracingparts.com for the most current instruction information
PLEASE READ ALL OF THE FOLLOWING INSTRUCTIONS CAREFULLY PRIOR TO INSTALLATION. AT ANY TIME YOU DO NOT UNDERSTAND THE INSTRUCTIONS, PLEASE CALL THE FORD RACING
- TECHLINE AT 1-800-367-3788 ! ! !

Item		Description
1		Floor console finish panel
2		RH floor console side panel
3		Floor console finish panel clips (6)
4		Floor console side panel clips (4)
5		Floor console rear screws (2)
6		Floor console front screws (2)
7		Floor console assembly
8		LH floor console side panel
9		Side panel push pin (2)

STEP 1 : Set parking brake
STEP 2: Place shifter in neutral
STEP 3: Remove shifter cover/heater control faceplate. Gently pull up on rear of shifter cover/faceplate. It is retained by push in clips.
STEP 4: After the shifter cover/faceplate is free of console, gently pull straight back freeing it from the dash around the heater controls. Disconnect any wires.
STEP 5: Remove console side panels #2 and #8 by removing the push pins at the front of the panels. Pull rear of panels to free the push in clips. Set panels aside.
STEP 6 : Remove shifter boot by unscrewing the shifter knob. Lift shifter boot at base freeing it from console.
STEP 7 : Remove console bolts #5 and #6. Unplug any electrical connectors at front sides of console. This allows you to shift console back and lift the front of it to gain access to shifter.
NOTE : Floor console finish panel item #1 is not removed from Floor console assembly item #7 during installation of the shifter.
STEP 8: Remove shifter cables from shift levers.
STEP 9: Remove shifter cables from base
STEP 10: Remove the 4 nuts retaining the shifter assembly. Lifting console provides better access to nuts.
STEP 11: Holding front of console up remove shifter out through side.