DORMAN 926-062 Ignition Lock Cylinder Instruction Manual
- June 1, 2024
- DORMAN
Table of Contents
DORMAN 926-062 Ignition Lock Cylinder Instruction Manual
Removal Instructions
STEP 1: Disconnect negative battery cable.
STEP 2: Remove column lower shroud mounting screws and remove upper and
lower shrouds from column.
STEP 3: Unplug wire pigtail from ignition lock if equipped.
STEP 4: Turn ignition to run position.
STEP 5: Press in ignition lock release tab using a small screw driver or
similar tool and pull lock out from column.
Installation Instructions
STEP 1: Install new ignition lock assembly by pushing lock into column.
STEP 2: Connect new ignition lock pigtail if equipped.
STEP 3: Reinstall column shrouds and mounting screws.
STEP 4: Verify free rotation of new lock through all positions.
STEP 5: Reconnect negative battery cable.
We appreciate your opinions regarding this product!
Please call our Technical Assistant with any challenges or suggestions
regarding the installation or operation of this product.
1-800-523-2492
Disclaimer:
Even though every attempt is made to ensure this information is complete and
accurate, it is impossible to account for all possible circumstances or
situations. Please consult with a qualified auto technician before attempting
to perform any work you are not qualified to do. Automobiles can be hazardous
to work on; be sure to take all necessary safety precautions. Failure to do so
may result in property damage or personal injury. Certain motor vehicle
standards and performance requirements may apply to your motor vehicle (such
as Federal Motor Vehicle Safety Standards by the National Highway Traffic
Safety Administration). Be sure that your work is performed in accordance with
such standards and that you do not disable any motor vehicle safety feature.
©2018 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>