GENERAC GGCAC Generator Connectivity Accessory Air Cooled Installation Guide
- June 1, 2024
- Generac
Table of Contents
GENERAC GGCAC Generator Connectivity Accessory Air Cooled
Install The Accessory
Install the Mounting Plate
Place mounting plate in cutout in end panel.
Align the plate with “TOP” pointing toward the top of the end panel.
Drill Mounting Holes
With the end panel on a flat, firm, and smooth surface, drill 3x holes into the end panel using #3 drill bit, using the holes in the mounting plate as a guide.
Affix the Mounting Plate
Place the three {3) M4 bolts through the mounting plate and affix using the three {3) M4 nuts. Tighten using a wrench and a drill.
Route the Cable Harness
Route the radio harness through the hole from the generator controller to the exterior.
Attach Radio Harness to Connectivity Accessory
OSA
Align key with slot in connectors
05B
Press connectors together
o5c
Tighten nut on radio harness
Attach Connectivity Accessory to End Panel
06A
Align the ARROW on the accessory with the ARROW on the mounting plate.
06B
Press the Accessory flush with the mounting plate.
06C
Turn the Accessory clockwise to attach
06D
click will be heard when the accessory is fully installed
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>