PETZL E0087600C How Lamp Works Head Torch Light Instruction Manual
- June 1, 2024
- PETZL
Table of Contents
- PETZL E0087600C How Lamp Works Head Torch Light
- Product Usage Instructions:
- REACTIVE LIGHTING® Technology
- Lighting performance
- General information on Petzl lamps
- Cleaning, drying
- Protecting the environment
- Questions/contact
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
PETZL E0087600C How Lamp Works Head Torch Light
Specifications
- Model: NAO RL
- Rechargeable Battery: Petzl Li-Ion, 3200 mAh capacity
- Charging Time: 3 hours and 30 minutes
- Charger Output Voltage: Not to exceed 5V
- LEDs: White LEDs for main lighting, Red lighting also available
- Usage Restrictions: Not recommended for children under 3 years old, supervision needed for children under 12
Product Usage Instructions:
Lamp Operation
To turn on the lamp, use the Lamp switch (1) and to turn off, use the same
switch. The Battery switch (1 bis) controls the battery power.
Charging the Rechargeable Battery
Ensure the Petzl R1 rechargeable battery is fully charged before first use.
Use only a USB Type-C cable with a maximum output voltage of 5V. Charge for 3
hours and 30 minutes using the provided USB charger or a computer. Do not
leave the battery unattended while charging.
Replacing the Rechargeable Battery
To replace the rechargeable battery, ensure it is compatible with the Petzl
NAO RL model. Follow the manufacturer’s instructions for proper replacement.
Using Lamp in Light Fixture Mode:
The headlamp can be used as a light fixture connected to a power grid.
Ensure all accessories are certified according to electromagnetic
compatibility standards IEC 61000-4-4, IEC 61000-4-5, and IEC 61000-4-6.
FAQ
-
Q: Can children use this headlamp unsupervised?
A: No, the lamp is not recommended for children under 3 years old and children under 12 should use it under adult supervision. -
Q: How long does it take to charge the battery?
A: Charging time is 3 hours and 30 minutes with the provided USB charger or a computer. Note that charging time can vary if multiple devices are connected to the computer. -
Q: Can I use a different rechargeable battery with the lamp?
A: It is recommended to use only the Petzl R1 rechargeable battery with this lamp to ensure proper functionality and safety.
WARNING
Before using this headlamp, you must:
- Read and understand all Instructions for Use.
- Become acquainted with its capabilities and usage restrictions.
- Understand and accept the risks involved.
FAILURE TO HEED ANY OF THESE WARNINGS MAY RESULT IN SEVERE INJURY OR DEATH.
Before using this headlamp, you must:
- Read and understand all Instructions for Use.
- Understand and accept the risks involved.
- Become acquainted with its capabilities and usage restrictions. Lamp not recommended for children under 3 years old. Children under 12 years old using this headlamp must do so under responsible adult supervision.
Failure to heed any of these warnings may result in severe injury or death.
Nomenclature
(1) Lamp switch, (1 bis) Battery switch, (2) Light sensor, (3) White LEDs, (4)
Reflective headband, (5) R1 rechargeable battery, (6) USB port for charging
the rechargeable battery, (7) Type A/C USB cable, (8) Energy gauge, (9) Red
lighting, (10) Top strap, (11) Storage pouch.
REACTIVE LIGHTING® Technology
Using REACTIVE LIGHTING® technology, a sensor analyzes the ambient light and automatically adjusts brightness to user needs.
Lamp operation
Turning on & off, selecting
- The lamp has two modes (REACTIVE LIGHTING® and CONSTANT LIGHTING) and three brightness levels per mode (MAX BURN TIME, STANDARD and MAX POWER).
- When you turn on the lamp, it always lights up with REACTIVE LIGHTING® technology.
- When switching from one mode to another, it stays at the same brightness level.
- With REACTIVE LIGHTING® technology, when the sensor detects an area with sufficient light, the lamp will blink dimly for two minutes, then automatically turn off to conserve rechargeable battery life.
- The lamp’s burn time in REACTIVE LIGHTING® mode varies depending on usage.
- For high-speed activities (cycling, skiing…), we recommend using the lamp in CONSTANT LIGHTING mode (there is a risk of it turning off in REACTIVE LIGHTING® mode).
- REACTIVE LIGHTING® mode: the lamp’s brightness can vary greatly, depending on the environment and the activity. Be sure to adapt your lighting (mode and brightness) to your activity.
- The energy gauge lights when the lamp is turned on or off. One short press of the battery switch lights the energy gauge.
- Reserve lighting: the lamp blinks when it switches to reserve lighting, and 5 minutes beforehand. When the lamp switches to reserve lighting, it provides enough light to walk by, but not enough for a dynamic activity (such as running, mountain biking, skiing…).
Lighting performance
The burn time values for REACTIVE LIGHTING® and CONSTANT LIGHTING are measured with the rear red strobe turned on.
Charging the R1 rechargeable battery
The lamp comes with a Petzl Li-Ion rechargeable battery. Capacity: 3200 mAh.
Charge it completely before first use.
Use only a Petzl R1 rechargeable battery.
In general, Li-Ion rechargeable batteries lose 10 % of their capacity each
year. After 300 charge/discharge cycles, they still have about 70 % of their
initial capacity.
WARNING
Charge only with a USB Type-C cable.
The charger’s output voltage must not exceed 5 V. Use only a Class II
electrical, CE/UL approved charger (double insulation against hazardous
voltages). Do not leave the battery unattended while charging. Your
rechargeable battery’s connectors must be dry when charging.
Charging time
Charging time is 3 hours and 30 minutes with the USB charger or a computer.
Note: if several USB devices are connected to a computer, the charging
time can increase.
During charging, the 5 LEDs on the energy gauge will blink. The blink speed
varies depending on the charging speed.
When charging is complete, the LEDs are lit a steady green.
Replacing the rechargeable battery
Use a Petzl R1 rechargeable battery. Using another external power source is
possible on rare occasions, mainly in an emergency situation.
In this case, full functionality of the lamp is not guaranteed (reduced
performance, no REACTIVE LIGHTING®…). Use only equipment that meets USB
standards.
Using the R1 rechargeable battery as a back-up battery
If necessary, you can use the R1 rechargeable battery to recharge your phone,
watch…
To start charging, do one short press on the battery switch. Note: charging
time may vary depending on the connected device.
In accordance with current electromagnetic compatibility regulations, the
battery may be subjected to power surges when it is connected to the power
grid for recharging. So it is necessary to use a charger with surge protection
(IEC 61000-4-5 standard or CE marking).
Using the lamp in light fixture mode
The headlamp can be used as a light fixture directly connected to the power
grid. For this, it is essential that the wall charger, as well as all USB
connection accessories are certified according to the electromagnetic
compatibility standards IEC 61000-4-4, IEC 61000-4-5 and IEC 61000-4-6. The
Petzl charger is suitable for this type of application.
General information on Petzl lamps
The EU declaration of conformity is available at
Petzl.com.
A. Rechargeable battery precautions
WARNING – DANGER: risk of explosion and burns.
WARNING: incorrect use can damage the rechargeable battery.
- Do not submerge the rechargeable battery in water.
- Do not dispose of a rechargeable battery in fire.
- Do not expose the battery to high temperatures. Follow the recommended usage and storage temperatures.
- Do not destroy the rechargeable battery; it can explode or release toxic materials.
- If the rechargeable battery is damaged, do not dismantle it or change its structure. Dispose of the rechargeable battery in accordance with current local regulations.
- If the battery leaks electrolyte, avoid any contact with this corrosive and dangerous liquid; see a doctor if any contact occurs. Change out the battery and dispose of the defective battery in accordance with current local regulations.
Lamp precautions
WARNING: a headband can pose a strangulation risk. Certain small parts
pose a choking risk.
Eye safety
The lamp is classified in risk group 2 (moderate risk) according to the IEC
62471 standard.
- Do not stare directly at the lamp when lit.
- The optical radiation emitted by the lamp can be dangerous. Avoid aiming the lamp’s beam into another person’s eyes. Beware of the risk of blinding others in your work environment, particularly in areas subject to traffic regulations.
- There is a risk of retinal damage from the emission of blue light, particularly in children.
Electromagnetic compatibility
Meets regulations concerning electromagnetic compatibility. WARNING: this does
not guarantee that interference will not occur. If you notice electromagnetic
interference between the lamp and electrical devices, turn off the lamp or
keep it away from sensitive electronic devices (e.g. avalanche beacons, flight
controls, communications equipment, medical devices…).
ErP Directive
Complies with energy-related products Directive (ErP) 2009/125/EC.
- Instantaneous full brightness – Color temperature: 6000-7000 K – Focused beam nominal angle: 15° / wide: 36° – Number of switching cycles before failure: 13,000 minimum.
Cleaning, drying
If used in a damp environment, remove the battery from the lamp and allow it to air dry. In the event of contact with seawater, rinse the lamp in fresh water and dry it.
Storage, transport
For long-term storage, charge the rechargeable battery (repeat every six
months) and disconnect the battery from the lamp. Avoid allowing the
rechargeable battery to discharge completely. Be sure to store the battery in
a dry place. The ideal storage temperature is between 20 and 25° C. After 12
months in these conditions without use, the rechargeable battery will be
discharged.
For carrying the lamp when not in use, we recommend that the battery be
disconnected from the lamp to prevent it accidentally turning on.
Protecting the environment
Dispose of the lamp only in accordance with current local regulations.
Modifications/repairs
Prohibited outside of Petzl facilities, except replacement parts.
The lamp’s light source is not replaceable. When the light source reaches the
end of its life, the lamp must be retired.
The lamp’s flexible exterior cable can not be replaced: if the cable is
damaged, the lamp must be retired.
Questions/contact
The Petzl guarantee
This lamp is guaranteed for 5 years against any defects in materials or
manufacture (except the rechargeable battery, which is guaranteed for 2 years
or 300 cycles). Exclusions from the guarantee: more than 300 charge/discharge
cycles, normal wear and tear, oxidation, modifications or alterations,
incorrect storage, poor maintenance, damage due to accidents, to negligence,
or to improper or incorrect usage.
Responsibility
Petzl is not responsible for the consequences, direct, indirect or accidental,
or any other type of damage befalling or resulting from the use of its
products.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>