Danfoss IK1-G Remote Control Installation Guide
- June 1, 2024
- Danfoss
Table of Contents
Danfoss IK1-G Remote Control
Product Specifications
- Model: IK1-G Remote Control
- Battery Type: AA LR03 Alkaline (4 batteries required)
- Battery Capacity: 900-1155 mAh
- Features: LCD Display, Stop Button, Start Button, Status LEDs, Toggle Switches, Thumb Joysticks, Side Pushbuttons, Proportional Trigger, Internal Magnet, External EEPROM module, Tether Connector
Installation
- Ensure the machine is stopped before starting the installation process.
- Keep the work area clear and wear protective clothing.
Battery Installation
- Insert 4 AA LR03 Alkaline batteries or a compatible rechargeable BT11K battery pack into the transmitter.
- For LiIon Batteries BT11K, charge them as per the Battery Charger instructions.
Installation Guide
IK1-G
Remote Control
- Danfoss does not take responsibility for incorrect installation or any frequency interference.
- Chance of unintended machine movement on start up. Ensure the machine is stopped for the entire duration of the assembly process.
- Keep the work area free and wear protective clothing.
- To guarantee the specified autonomy or the product, it is necessary to use AA LR03 (x4) Alkaline batteries with nominal capacities between 900 and 1155 mAh. It is highly recommended to use brands with PLUS type or similar with nominal capacities close to 1155 mAh. Rechargeable batteries are not recommended because of their lower nominal capacity.
The illustration below details dimensions and features of the IK1 transmitter.
- STOP Button
- Status LEDs (2)
- Toggle Switches
- Thumb Joysticks
- Side Pushbuttons (up to 5)
- Proportional Trigger
- Internal Magnet
- External and extractable EEPROM module
- LCD Display
- Alkaline Battery Pack (4xAA) or Rechargeable BT11K Battery
- Tether Connector
- START Button
In order to turn the transmitter ON (OPERATION mode), please follow these
steps:
Start up the device
-
Place a charged LiIon battery or Alkaline Battery Pack (4xAA Batteries) on the transmitter.
Li-Ion Batteries BT11K must be charged following the instructions of the Battery Charger. -
Push and pull out the STOP button.
LED status (blue)
LED will flash, blinking blue until it reaches the Stand-by mode (fixed blue). If the transmitter includes a Display, it will display the identification of the machine, as well as the battery level, if it has been pre-programmed. -
Press the START button, and wait for the status LED to turn to fixed green.
LED status (green)
The status LED will start blinking green, meaning the transmitter is trying to connect with the receiver. Once the Tx is linked, LED will turn to fixed green. -
Press any of the transmitter’s maneuver buttons and its corresponding relay will be activated.
-
Check to make sure all the maneuvers work in a coherent way with the expected movements by checking the supplied production sheet, included with the system.
Receiver User Manuals & Datasheets
Transmitter User Manuals & Datasheets 
Danfoss can accept no responsibility for possible errors in catalogues,
brochures and other printed material. Danfoss reserves the right to alter its
products without notice. This also applies to products already on order
provided that such alterations can be made without subsequent changes being
necessary in specifications already agreed.
All trademarks in this material are property of the respective companies.
Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights
reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>