LUXRITE LR23227 12W LED Regress Spotlight Gimbal Round Instruction Manual
- September 26, 2024
- LUXRITE
Table of Contents
LUXRITE LR23227 12W LED Regress Spotlight Gimbal Round
IMPORTANT
IMPORTANT: READ ALL INSTRUCTIONS BEFORE INSTALLING FIXTURES. KEEP FOR
FUTURE REFERENCE.
SAFETY: FOR YOUR SAFETY, THIS FIXTURE MUST BE WIRED IN ACCORDANCE TO
LOCAL ELECTRICAL CODES AND ORDINANCES. ALL WORK SHOULD BE DONE BY A QUALIFIED
ELECTRICIAN.
WARNING: MAKE CERTAIN POWER IS OFF FROM THE ELECTRICAL PANEL BEFORE
STARTING INSTALLATION OR ATTEMPTING ANY MAINTENANCE. INDOOR INSTALLATION ONLY.
TOOLS REQUIRED : SAW, MEASURING TAPE, ELECTRICAL WIRING (USE TAPE AND
GAUGE SUITABLE FOR APPLICATION TO CONNECT THE FIXTURES).
PRE-INSTALLATION
- Turn power OFF from the electrical panel before starting installation.
- Locate a suitable position to place the fixture and open in accordance to the cut-hole dimensions (refer to Hole Cut Table for appropriate size)
- Run electrical wire from the switch (power supply) through the mounting hole -use NMD90 Romex or BX cable.
DRIVER WIRING
-
Open the hardwire box swing cover and remove the appropriate knockout(s).
-
Insert the electrical supply cable through the knockout and secure with a cable conneotor (sold sepparately).
-
Using wire nuts, connect green ground wire of cable to green wire on box. Connect black wire of cable to black wire of box. (Fig. 1)
-
Place all wiring a nd connections back into the box and close the cover. ( Fig. 2)
-
Insert hardwire box through the mounting hole. **(Fig. 3)
**
NEW CONSTRUCTION APPLICATIONS: Hardwire box shall be firmly secured to studs, joists, or similar fixed structura units.
REMODEL APPLICATIONS: Do not require the hardwire box to be firmly secured after the mounting plates, studs, joists, or structural units have been concealed.
FIXTURE INSTALLATION
-
Connect the fixture to the hardwire box by inserting and twisting the male/female connectors and select Color Temperature (Fig. 4)
-
Push spring loaded clips on the fixture upwards and insert fixture base into the mounting hole. Release the clips and fixture will be pulled flush to the ceiling. (Fig. 5)
-
Once assembly is complete, turn on power to confirm fixture is working properly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>