KEINVE KE1220 Electric Tea Hot Water Kettle Electric Instruction Manual

INSTRUCTION MANUAL ELECTRIC KETTLE
ModelNo.:KE1220

IMPORTANT SAFEGUARDS

• All contents of this item are related to safety, so users are requested to observe them.
• The precautions in this item are mainly for the proper use of the product. The precautions explain the dangers, the magnitude of the hazards, and the possible accidents.

1. Read and familiarize yourself with all operating instructions before using this kettle.
2. Before plugging your kettle into the mains, visually check that the kettle is intact and has not suffered any transit damage.
3. Before connecting the kettle, check that the voltage indicated on the nameplate corresponds to the voltage of the local grid.
4. Only use accessories that were provided or recommended by the manufacturer.
5. Test the electrical kettle and cable regularly for damage. If there is any damage, do not use it.
6. If the supply cord is damaged, it must be replaced by the manufacturer, or an authorized service station in order to avoid danger.
7. Do not repair the device yourself; always consult an authorized expert.
8. Always unplug the appliance when not in use.
9. During use, only use the handle. Do not touch the body of kettle to avoid scalding.
10. The kettle is intended to heat water only, do not use the appliance for any other purpose as this may damage the appliance.
11. Keep the electrical kettle and cable away from heat, direct sunlight, moisture, sharp edges, etc.
12. Do not remove the lid while kettle is in use.
13. Do not use the electrical kettle outdoors.
14. This appliance is intended for household use only and should not be used for industrial purposes.
15. Never place this appliance on an electric, gas, or any other type of hob.
16. Do not plug in the kettle before adding water. In case of overheating, allow the kettle to cool down for at least 15 minutes.
17. Do not immerse the appliance, base or its cord in water or any other liquids.
18. Do not plug in or operate the electrical kettle with wet hands. If the kettle does get wet, unplug it immediately.
19. To turn off the appliance, press the power button, or manually remove the kettle from the base.
20. In order to protect children from the dangers of electrical appliances, never leave children unattended near the electrical kettle. Keep kettle out of reach of children and make sure the cable does not hang down the edge of the table or counter.
21. This appliance is not intended for use by persons (including children younger 8) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have supervision.
22. Cleaning and maintenance should not be done by children younger than 8 and supvised.
23. CAUTION: Do not fill above the MAX line, otherwise it may overflow from the spout or leak at the bottom when boiling.

Short Power-supply Cord Instruction:

1. A short power-supply cord is to be provided to reduce risks resulting from becoming entangled in or tripping over a longer cord.
2. Longer detachable power-supply cords or extension cords are available and may be used if care is exercised in their use.
3. If a long detachable power-supply cord or extension cord is used:
   a. The marked electrical rating of the detachable power-supply cord or extension cord should be at least as great as the electrical rating of the appliance;
   b. The extension cord should be a grounding type 3-wire cord;
   c. The longer cord should be arranged so that it will not drape over the counter top or table top where it can be pulled on by children or tripped over.

WARNING: Failure to follow the operating instructions may be dangerous.
CAUTION: Unauthorized operation may damage your belongings, property, or even jeopardize your personal safety.

READ AND SAVE THESE INSTRUCTIONS

BEFORE FIRST USE

Self-test: all the indicator lights flash once after power on, indicating that it can work normally. After the self-test is completed, it enters the standby “OFF” state, and the power-on state “ON”, and the actual water temperature will be displayed if there is no operation within 5 seconds.

SPECIFICATION

FUNCTIONS

• NOTE: When the kettle is in any of the modes and is in operation, the red light for that mode comes on and the green light for the end of operation.
• When the “Tea” or “Boil” mode is over, if there is no setting then the default temperature will be used to keep warm automatically, you can also customize the desired temperature.
• Hold temperature can be adjusted in both “Boil” and “Hold” modes. Temperature range 45℃/113℉~95℃/203℉.

Boil| Automatically holds after heating to 100° C/212° F (default hold temperature is 50° C/122° F). Hold time is 24 hours.
---|---
Tea| After heating to 100 °C /212 °F and keep heating for 2 minutes, keep warm automatically (default keep warm -45 °C /113 °F ). Keep warm for 6 hours.
Select “Time” Button to manually control the heating time (2-5 minutes).
Coffee| After heating to 92°C/198°F , it will turn off automatically (will not turn on keep warm automatically).
Hold| Heats up to preset temperature and keeps warm for up to 24 hours. Temperature range: 45°C/113°F-95°C/203°F.

OPERATING INSTRUCTIONS

How to use “Delay Timer”
Standby state click on the “Delay Timer” button, select the mode start time, confirm the time and then click on the “Mode” button to select the desired mode, 5 seconds after the automatic countdown (If you need to set the temperature of heat preservation, you can select the “Temp” button again to operate).
How to use “Tea” mode correctly
The “Tea” mode is divided into 2 stages – ① full power rapid heating to 100° /212°F; ② after boiling, automatically turn to low power to continue heating for 2-5 minutes.

1. Click “Tea” mode and select the “Time” button to adjust the heating duration of the second stage, and you can set the holding temperature according to your own needs.
2. How to make tea: Pour the tea into the strainer, put it into the kettle and put the lid on, then start to make tea. (You can choose whether to put the tea in the first stage or the second stage according to your preference)
3. The purpose of boiling tea is to better release the tea aroma and better flavor.
   Note: Not all teas are suitable for boiling tea, recommended black tea, pu-erh tea, flower tea, oolong tea.

CLEANING & MAINTENANCE

Always unplug the product before cleaning it.
Never use steel wool, abrasive cleaners, or caustic liquids (such as gasoline or acetone) to clean the product.
Never immerse the kettle in water or any other liquid.
Cleaning electric kettle.
Wipe the outer surface of the jug with a soft cloth moistened with warmwater and a non-hazardous cleaner.
Deal with limescale.

1. Regular descaling will prolong the life of the kettle.
2. The frequency of the decalcification depends on the hardness of the water in your area and how often the appliance is used
3. If the kettle switches off before it boils or has a white deposit building up inside then it probably needs to be decalcified.
4. Do not use vinegar but a commercially available decalcification agent; carefully follow the quantities recommended in the instructions of the agent.

Caution

1. Place the kettle on a flat, dry, stable surface when not in daily use.
2. The kettle should not be placed or stored close to other sources of heat.
3. Do not place debris on the kettle.

DISPOSAL

1. Do not dispose this product as unsorted municipal waste.Collection of such waste separately for special treatment is necessary.
2. This product must not be disposed together with the domestic waste.
3. This product has to be disposed at an authorized place for recycling of electrical and electronic appliances.
4. By collecting and recycling waste, you help save natural resources, and make sure the product is disposed in an environmental friendly and healthy way.

TROUBLESHOOTING

If you have problems with your pressure cooker, please follow the troubleshooting guide before contacting an authorized servicing agent.

the socket and that the socket is working.
2. Please go to the dealer service point for replacement before use.
Insufficient water or no water dry boil, dry burn protection function works after the power off| pour cold water into the keffle; reset security after approximately 2 minutes; then you can restart the kettle.
The kettle has a strange odor| Usually when the kettle is used for the first time, there will be this phenomenon.| Fill the kettle with water to the maximum mark, add two tablespoons of baking soda, boil the water, and then pour it out.
Auto shut-off before the boil| Caused by scale in the kettle| Troubleshooting by removing limescale and trying the product again.
Error Code| El
E2
E3| No kettle detected /temperature probe malfunction)
Temperature control probe short circuit
Dry burning (temperature control probe over temperature)

NOTE: The types of faults and common problems are not limited to the above, if the problem still exists, or other problems occur, please contact the after-sales service for more help. ****

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>