THULE 38202 12V 700mm Slide-Out Step Instruction Manual

: June 1, 2024
: THULE

Table of Contents

38202 12V 700mm Slide-Out Step
INSTALLATION
**USE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LED Lights for Thule Steps
12V 400-500
Instructions
Prod.nr. 38202
2S906-07
INSTALLATION INSTRUCTIONS

38202 12V 700mm Slide-Out Step

Read these instructions carefully. No guarantee will be allowed for wrong installation.
The LED’s can be mounted on every Thule Step 12V with anti-slip footboard, for which the total width is between 406 and 551mm.
CONTENTS
– LED strip with cable (3M) …………… 1
– Translucent anti-slip profile 54…….. 1
– Strap………………………………………….. 1

INSTALLATION

Open the step.
Remove the front anti-slio rubber profile from the groove by pulling upwards. See fig. 1.
Remove the screws from both sides of the step. Fig. 2.
Remove the plastic inserts from the corners and the footboard. See fig. 2.
Drill a 7mm diameter hole in the left hand side profile. See fig. 3 detail 1.
Only for slide-out steps:
5a. Remove the plastic cover plate from the underneath of the casing by firstly unscrewing the four screws in the front or back cover plate by about Icm each and then ease out the cover at the front of the box.
5b. Drill a second hole of 10mm dia. See fig. 3 detail 2. This is possibly already predrilled but if so with a 5mm dia.
Feed the cable from the LED’s through the 7mm dia hole in the profile, till it exits the profile at the top. Fig. 4.
Position the LED strip in the groove of the footboard, with the LED’s facing upwards. See fig. 4.
Replace the plastic pieces on the corners and screw the footboard back into place. Pay attention that the screws do not interfere with the cable. Ensure that the screws are fully tightened.
Push the translucent anti-slip profile into the groove and cut to the correct length. Ensure that you do not stretch the profile. It is better to cut it longer in order that it will be compressed into the groove.
Also
Only for the slide-out:
10a. Ensure that the cable is exiting the profile through the 10mm drilled hole! See fig. 5a.
10b.Feed the cable through the hole at the back of the box together with the cables from the motor. Attach the cable to the motor with the strap. Fig.Satb. Check that the cable does not harm the movement of the step.
10c. Close the box.
Connect the electrical cable (switch, movement detector…). It is very important to ensure that the wires are connected properly: the red cable to the +(positive), the white to the – (negative). Check that the cable cannot be damaged or compressed by any moving parts.

**USE

**

Use the LED’s with a switch (manual, movement detector, obscurity switch, …).
OPTION (see scheme fig. 6)
Relay for automatically switching on the LED’s when operating the step. The relay switches the power off when in the closed position. Meets the EMC standards 89/336/EEC.

THULE 38202 12V 700mm Slide Out Step - FIGURE 1