SCUDO Momentum Sliding Door Recessed Installation Guide
- June 1, 2024
- SCUDO
Table of Contents
SCUDO Momentum Sliding Door Recessed
BEFORE YOU START
IMPORTANT NOTICE
Please assemble according to our instructions, otherwise the enclosure will
not be stable. Please check accessory quantities after you open the carton to
ensure all fittings are included.
IMPORTANT NOTICE
Trat must be sealed fully around where the tray meets the wall. Tray must be
100% level in all directions. Ensure the shower tray is level in all
directions and is properly sealed to the wall. The wll must be tiled down to
the top edge of the tray. Do not angle out bottom tile.
TOOLS AND MATERIALS REQUIRED
TOOLS & MATERIALS SUPPLIED
Note! Additional tools and materials may be necessary, depending on the
specific requirements of the site.
WHAT IN THE BOX
INSTALLATION INSTRUCTION
IMPORTANT FOR PROPER CLEANING
Your shower enclosure is designed for minimum cleaning effort. To keep your
shower enclosure permanently shining, a few rules must be observed.: Profiles
and glass may only be cleaned with light cleaning agents. Abrasive cleaning
agents, alcohol or nitric solutions must not be used. Do not use steel wool or
course microfibre cloths for cleaning, as this will cause scratches. limescale
in the water causes satins, so frequent cleaning is essential to keep your
screen clean. The longer the limescale remains, the more difficult it is to
remove.
MAINTENANCE OF MECHANICAL PARTS
The mechanical parts of the screen also need maintenance to ensure that they
will function perfectly for many years to come. The bearings and hinged parts
of the screen should be lightly lubricated. Screws that remain visible should
also be tightened.
EASY-CLEAN COATING
The easy-clean coating is a special treatment that gives the glass an extra-
smooth surface coating that prevents water droplets, soap dirt or limescale
from adhering to the glass. Cleaning is not prevented, but all residues are
easily and effortlessly removed. To clean the easy-clean coated glass surface,
non-abrasive cloths and cleaning agent should be used.