Reichelt RC810 Remote Control Instruction Manual
- June 1, 2024
- REICHELT
Table of Contents
Reichelt RC810 Remote Control Instruction Manual
Never operate the mount without a TV installed!
Before power connection, be sure that bracket and the TV installed correctly.
Keep the children away from power. Do not swivel the mount using hands.
OK : Stop Button
HL 48 ML / HL 48 MWL
RMT-03 remote control, 2x AAA battery (not included)
Reset Mode
If the TV mount can‘t be adjusted to the highest position (0° against the
ceiling) or the lowest position (max. tilting position), unplug and
re-plug the power. Then press and hold the OK button for 5 seconds.
Mount will retract to the highest position, that means the system has been
successfully reset.
Note: Long press SET for 5 seconds to disconnect the device from the
app.
Coding of Remote Controller and Control Box
Step 1: When the mount is powered on, press the small button on the
control box with a thin tool as shown. The unit emits a beep, indicating that
the control box is on standby for program coding.
Step 2: Press the SET button on the remote control within 10
seconds after Step 1. The control box will repeat beeps for approximately 10
seconds indicating that the remote control is being programmed. The process
will automatically finish when you no Ionger hear any beeps.
NOTE: The TV Mount can be matched with up to 20 remote controllers. To
clean up the data of all the remote controllers and the phone , press and
hold the code matching button for 5 seconds then release. The unit will emits
two beeps confirm the
successful clean up and vice versa.
Hereby, Transmedia Kabelverbindungen GmbH declares that the Folding Suspension Brackets for Flat Screens HL 48 ML and HL 48 MWL are in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.transmedia- germany.com/download