Sensata DP700 MK2 Digital Readout System User Guide
- June 1, 2024
- Sensata
Table of Contents
Sensata DP700 MK2 Digital Readout System User Guide
For the complete manual please download from:
http://newall.com , Click Technical Support to access the
download page.
Warnings
The mains supply is connected into a switch mode power supply (separate from
your DP700) via a
detachable supply cord supplied. If another supply cord is used, it must have
fitted a C5, 10A, EARTHED mains connector with a cord rated for at least 10A.
If a mains plug is not already fitted to the supply cord or is of the wrong
type, then a suitable EARTHED plug should be used which complies with the
relevant specifications for plugs and socket outlets.
You can only use the DP700 with Newall Spherosyn and Microsyn analogue
encoders.
Unit only to be serviced by Newall qualified personnel or authorised
alternatives.
Turn off the power by disconnecting the power supply connector before you
connect the encoder(s)
Technical Specification
Environmental
Operating Temperature Storage Temperature
-10°C to 50°C -20 to 70°C
Environmental Condition s – IP40 (Stand Alone) IP54 (Panel Mount)
Relative Humidity – maximum 95% for temperature up to 31°C
Disposal
At the end of it’s life, you should dispose of the DP700 in a safe manner
applicable to electronic goods.
The case work is suitable for recycling. Please consult local regulations on
disposal
Electrical
EU Directive 73/23/EEC (Low Voltage
Directive)
BS EN 55022:1998 Class B
BS EN 55024:1998
Input to Power Supply Unit (Supplied)
100-240V (47-63Hz)
External switch-mode
Output voltage 15VDC
Input Voltage to DP700
15-24VDC ±10%
Conforms to Low Voltage Directive
Note: Newall Measurements Systems reserves the right to change
specifications without notice.
Connections
Understanding the Keypad
Axis Selection Key| | Numeric Keys| | Enter Key| | Clear Numeric Entry|
---|---|---|---|---|---|---|---
Center Find| | Undo Key| | Digifind / Reference| | Switches between Zero and
Axis Preset modes|
Switches between Absolute and Incremental modes| | Switches between Inch and
mm display| | Information selection (scrolls through options on Message
display)| | Function Menu Key|
Function Navigation Keys| | Sleep key| | | | |
Zero an Axis in Zero Mode
Ensure DP700 is in Zero Mode
of Axis 1, 2 or 3
Zero an Axis in Set Mode
Ensure DP700 is in Set Mode
Preset an Axis
Ensure DP700 is in Set Mode
**ENTERING SETUP
** Until display shows
display shows
SETTING UP THE UNIT
Must be set to match encoders on the machine
AMERICAS Newall Electronics Inc. 1803 OBrien Rd Columbus, OH 43228
Tel : +1 614 771 0213
sales@newall.com
newall.com
REST OF WORLD
Newall Measurement Systems,Ltd. Business Park, Unit 1 Wharf Way Glen Parva,
Leicester LE2 9UT
United Kingdom
Tel : +44 (0) 116 264 2730
sales@newall.co.uk
newall.co.uk
References
- Newall Measurement Systems - Linear Encoders and Digital Readouts (DRO) - Digital Readout Systems and IP67 Linear Encoders
- Newall Electronics - Digital Readout (DRO) and Linear Encoders
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>