Sensata CR402X Smart Witness User Manual
- May 15, 2024
- Sensata
Table of Contents
Sensata CR402X Smart Witness
Regulations & Safety Advice
FCC Regulations:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiated
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation if this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RF Exposure Information
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm(8 inches) during normal operation.
ISED Notice
This device complies with Innovation, Science and Economic Development Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003
ISED Radiation Exposure Statement
This device complies with RSS-102 radiation exposure limits set forth for an
uncontrolled environment.
In order to avoid the possibility of exceeding the ISED radio frequency
exposure limits, human proximity to the antenna shall not be less than 20cm (8
inches) during normal operation.
Caution
To reduce the risk of electric shock, do not remove cover. No user-serviceable
parts inside. Refer servicing to qualified service personnel. Please make sure
you follow the safety advice/instructions given in the user guide.
Caution
Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions. Battery for real-time clock (RTC)
inside.
Caution
Install the product where it does not block driver’s visibility and where
there is no air bag installed. This could cause an accident or might injure
passengers in case of accident.
WARNING
To prevent fire or electric shock hazard, do not expose this appliance to rain
or moisture.
Caution
Damages due to production malfunction, loss of data or other damages occurring
while using this product shall not be the responsibility of the manufacturer.
Although the product is a device used for recording videos, the product may
not save all videos in the case of a malfunction. In the case of an accident,
the sensor may not recognize the shock when the impact is light, and as a
result, it may not begin recording automatically.
Caution
Please make sure you follow the safety advice/instructions given in DC4000
instruction materials.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>