ideal lux D30 Universal PL Round Wall and Ceiling Lamp Instruction Manual
- June 1, 2024
- ideal lux
Table of Contents
ideal lux D30 Universal PL Round Wall and Ceiling Lamp
Product Information
Universal PL D30 Round
- LED: 25W / 220~240V 50/60Hz
- Color Temperature: 3000K – 8021696321684 4000K
- Manufacturer: IDEAL LUX srl
- Manufacturer Address: Via Taglio Destro 32, 30035 Mirano (VE), Italy
- Website: www.ideal-lux.com
Specifications
- EAN: 8021696138619
- Model: UNIVERSAL D30
- Light Source: LED
- Efficiency Class: F
- Light Source Current: 300 mA
- Light Source Voltage: 72 V DC
Product Usage Instructions
Installation
The lighting fitting should be installed by a qualified electrician following the assembly instructions provided in numerical order.
Replacing Light Source
This product allows for the light source to be replaced by an end-user. Make sure to replace it with a compatible light source.
Safety Instructions
- Always disconnect from the power supply before installation or maintenance.
- Avoid looking directly at the light source to prevent damage to the eyes.
- Use appropriate mounting accessories and follow local safety regulations during installation.
Frequently Asked Questions
- Can the LED light source be replaced by the user?
- Yes, the LED light source is replaceable by the end-user.
- Is it safe to install the product without consulting a qualified electrician?
- Well, it is recommended to have the product installed by a qualified electrician for safety reasons.
Wall and ceiling lamp
More Info
Warning
Installation Instruction
This product is provided with a light source with efficiency energy class of:
LEGENDA ICONE
- Replaceable light source by an end-user.
- Replaceable LED light source by an end-user.
- Replaceable light source by authorized personnel only.
- Non-replaceable light source. Upon end of life of the light source, the whole product will be replaced.
- Replaceable control gear by an end-user.
- Replaceable light source by authorized personnel only.
- Upon end of life of the control gear, the whole product will be replaced.
SAFETY INSTRUCTIONS
- This fitting is produced and tested in accordance with the strictest European safety standards (EN 60.598- 1).
- This fitting cannot be disposed of as household waste. For disposal information ask the local authorities about how to collect it.
- As indicated by specific regulations, the lighting fitting should be installed by a qualified electrician.
- If the external wire is damaged it has to be replaced exclusively by the manufacturer, distributor or by a qualified electrician.
- Always isolate power before commencing installation, maintenance or repair.
- The luminaire contains certain parts which can be very hot.
- Each material requires specific mounting accessories. Use screws and wall plugs suitable for the material to which they are fastened. Those included may be unsuitable.
- Always tighten the screws firmly to avoid contact problems.
- This fitting should only be installed indoors.
- Luminaires are not suitable for recessed on normally flammable surfaces.
- Luminaire is not suitable for direct mounting on normal flammable surfaces.
- This fitting is only suitable for fixing to the ceiling.
- This fitting is only suitable for fixing to the wall.
- The weight of the lamp has to be supported by the chain. Adjust the length of the electric wire so that it is longer than the chain.
- Only use lamps which do not exceed the maximum specified wattage.
- Always observe the minimum distance between the lamp and the surface being lit, as shown in the icon. The lamp can cause a fire if the minimum distance is not observed.
- Auto-protected bulb. Only use bulbs marked with this symbol. Halogen bulbs get very hot. Wait until they cool down before replacing.
- Cracked or broken safety glass has to be replaced immediately. Use only manufcturer approved parts complying with regulations.
- Light source with not-substitutable light emitting diode (LED). Do not disassemble the product since the diodes can damage the eyes. Do not immerse in water. Wipe with a damp cloth. Do not use solvents or strong detergents.
- This fitting is equipped with a fuse. If the lamp is out of order, replace the internal fuse.
- Class | Electrical safety guaranteed by the main insulation and an additional protective conduc- tor (earthing) connected with the metal frame of the lamp. Earthing is obligatory.
- Class Il Electrical safety guaranteed by the main insulation and a double or reinforced insulation.Earthing not necessary.
- Class Ill Electrical safety guaranteed by very low power supply (less than 50 Volt). Earthing excluded.
- Not protected.
- Protected against solid objects greater than 50 mm.
- Protected against solid objects greater than 12 mm.
- Protected against solid objects greater than 2,5 mm.
- Protected against solid objects greater than 1mm.
- Dust protected.
- Totally protected against dust infiltration.
- Not protected.
- Protected against vertically falling water drops.
- Protected against water drops falling with a maximum angle of 15° to the vertical axis.
- Protected against rain.
- Protected against splashing water.
- Protected against water jets.
- Protected against strong water jets.
- Protected against temporary immersion.
- Protected against prolonged immersion.
- Luminaire not suitable for covering with thermally insulating material.
- Caution, risk of electric shock.
- Do not stare at the operating light source.
IDEAL LUX s.r.l.
- Via Taglio Destro 32
- 30035 Mirano (VE) Italy
- www.ideal-lux.com
DEAL LUX Warehouse
- Via delle Industrie, 8/D
- 30036 Santa Maria di Sala (Venezia)
- 8.00 – 12.00 / 13.30 – 17.00
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>