IMMERGAS 3.035409 Floor Support Kit User Manual
- June 1, 2024
- IMMERGAS
Table of Contents
IMMERGAS 3.035409 Floor Support Kit User Manual
GENERAL WARNINGS.
All products are protected with suitable transport packaging.
The material must be stored in dry environments and protected against weathering.
This instruction manual provides technical information for installing the kit. As for the other issues related to kit installation (e.g. safety in the work site, environment protection, injury prevention), it is necessary to comply with the provisions specified in the regulations in force and principles of good practice.
Improper installation or assembly of the appliance and/or components, accessories, kit and devices can cause unexpected problems to people, animals and objects. Read the instructions provided with the product carefully to ensure a proper installation.
Installation and maintenance must be performed in compliance with the regulations in force, according to the manufacturer’s instructions and by authorised professionally qualified staff, intending staff with specific technical skills in the plant sector, as envisioned by the Law.
PRODUCT DESCRIPTION.
This optional kit is used to fix the external units of Thor-Goths and Multi air conditioners to the floor.
KIT COMPOSITION Cod. 3.035408 – 3.035409.
| Ref. | Q.ty | Description |
|---|---|---|
| 1 | 4 | TE screw M10x40 |
| 2 | 4 | TE screw M10x30 (Only for UE THOR 9) |
| 3 | 2 | PVC floor base (100x100x390 mm for UE THOR- GOTHA 9-12; 100X100X520 mm |
for all the others)
4| 4| PVC cap for floor base
5| 4| Anti-vibration 85x70x8 mm
6| 4| Washer M20 20×10,5×2 mm
7| 4| M10 hex nut
Excluded from the kit
8| 1| Outdoor Unit
INSTALLATION.
(Fig. 1).
Take the floor bases (3) and insert the screws (1 or 2 depending on the OU
model) into the groove, positioning them for fixing the outdoor unit.
(Fig. 2).
After having appropriately positioned the 4 screws (1 or 2 depending on the OU
model), insert the anti-vibration (5). Then position the external unit (8)
over the screws and fix it to the bases with the nuts (7), first inserting the
washers (6). Once assembly is complete, insert the caps (4) on the bases as
indicated in the figure and, if necessary, fix them to the bases using
silicone.
