BAOLIFENG CR-8 Wireless Earphone User Manual
- June 1, 2024
- BAOLIFENG
Table of Contents
BAOLIFENG CR-8 Wireless Earphone
DESCRIPTION
- ON/OFF/Switching Modes
- Pause/Play/Answer/Hang Up/Rejecting/Re-dialing
- Next Song/Volume Up
- Previous Song/Volume Down
- TF card slot
- Audio Port
- LED Indicator
- Type-C Charging Interface
- Microphone
SPECIFICATION
- Wireless version：5.3
- Frequency range: 2.402-2.480GHz
- Working range: 10m
- Music play time: 12H
- Talk time: 12H
- Charging time: 1.5H
- Frequency response: 20-20000Hz
- TF card support: 128MB-32GB
- Rechargeable Lithium Battery: 350mAh
How To Use
- Long press the for 3 seconds until the red and blue LED lights flash alternately.
- Turn on BT on the phone, search for the BT device”CR-8″, and connect the device manually for the first time.
- After the “CR-8” is successfully connected, there will be a prompt tone.
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution : Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>