SONIFEX AVN-DIO10-12G SD-SDI Embedder Instructions
- June 1, 2024
- SONIFEX
Table of Contents
- SONIFEX AVN-DIO10-12G SD-SDI Embedder Instructions
- AVN-DIO10-12G Dante® to 12G/6G/3G/HD/SD-SDI Embedder/De-Embedder
- Network Audio and Control
- Technical Specifications
- SDI Input
- Read More About This Manual & Download PDF
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
SONIFEX AVN-DIO10-12G SD-SDI Embedder Instructions
AVN-DIO10-12G Dante® to 12G/6G/3G/HD/SD-SDI Embedder/De-Embedder
An upgrade to the extremely popular AVN-DIO10, the new AVN-DIO10- 12G now adds
support for the full range of SDI standards from SD-SDI through to 12G-SDI.
The AVN-DIO10-12G can be used for simultaneous embedding and deembedding for
up to 64 channels. This simple plug and play audio/video interface provides a
convenient and elegant method of connec�ng legacy 12G/6G/3G/HD/SD-SDI
equipment to the Dante® AoIP audio network.
The AVN-DIO10-12G takes an SDI feed, de-embeds up to 64 audio channels and
places them on channels 1-64 on the Dante network, mapped using Dante
Controller. It simultaneously takes the 64 input channels mapped to the device
on Dante Controller and re-embeds them onto the SDI output.
The unit also contains an integrated SDI generator to allow embedding onto the
SDI output without the need of an SDI input. This is fully configurable
through the web UI.
Other controls provided through the web UI allow embedding of Dante channels
onto the SDI output per channel pair and there are two modes of operation:
Insert Mode enabled allows embedding to overwrite existng SDI audio selecfvely
per channel pair. Insert Mode disabled
clears any incoming audio channels on the SDI output and then allows selectve
embedding onto the SDI output per channel pair.
Network Audio and Control
Test Tone mode allows 1kHz, 2kHz, 3kHz and 4kHz signals to be outputon
channels 1 to 4 respectively, for any group where embedding is enabled. This
is so that downstream SDI audio outputs can be tested without the need of
Dante sources.
It’s powered by Power over Ethernet (PoE), using Neutrik® EtherCON connectors,
with primary and secondary ports for power and data redundancy. The AVN-
DIO10-12G uses the latest Audinate Dante® chipsets so is AES67 and Dante
Domain Manager® compliant. There are front panel LEDs to indicate network
clock status, SDI lock status, AoIP Primary and AoIP Secondary link status,
PoE Primary power and PoE Secondary power active.
A web interface is available for firmware updates, control, status information
and network settings.
Up to 3 of the AVN-DIO10-12G units can be rackmounted in the 1U AVN- DIORK.
Technical Specifications
SDI Input
*Check website for latest standards
www.sonifex.co.uk
sales@sonifex.co.uk +44 1933 650700