ASSA ABLOY IN100 Limited Modular Transmitter Integration Instruction Manual
- June 1, 2024
- ASSA ABLOY
Table of Contents
**ASSA ABLOY IN100 Limited Modular Transmitter Integration Instruction Manual
**
The IN100 RF Module is only intended for Assa Abloy products.
The IN100 PCB transmitter module and plastics are assembled at an Assa Abloy
contract manufacturer. Assa Abloy
provides all programming and test fixtures to our supplier to ensure the
limited modular assemblies remain
compliant.
Final assembly of the Module into the Host Products and Host Product testing
are done at an Assa Abloy factory per
our factory process.
For additional hosts other than the specific host originally granted with this
limited module, a Class II permissive
change is required on the module grant to register the additional host as a
specific host also approved with the
module.
Applicable FCC Rules:
FCC Part 15, Subpart C, Sections 15.225, 15.247 and 15.209
Applicable ISED Rules:
ISED Canada RSS-210 Issue 10 Annex B.6, RSS-247 Issue 2 and RSS-GEN Issue 5
Section 8.9
Host Labelling Instructions:
The module is labelled with its own FCC and IC certification numbers that are
not visible when inside the host.
Therefore, when the module is installed into the host a label containing the
following shall be applied in a visible area on the back of the Host assembly.
Contains:
FCC ID: U4A-SCYMCA1
IC: 6982A-SCYMCA1
Warning: Changes or modifications to this device are strictly prohibited.
This device complies with part 15 of the FCC Rules. This device contains
licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is
subject to the following two conditions:
- This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed.
RF Exposure:
The antenna(s) used for this module must be installed to provide a separation
distance of at least 20cm from all
persons and must not be collocated or operated in conjunction with any other
antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>