eurotech lighting BUL25 Bul Fixed LED Inground Uplighters Instruction Manual

June 3, 2024
eurotech lighting

eurotech lighting BUL25 Bul Fixed LED Inground Uplighters

All installations must be carried out by a qualified electrician following local regulations. Make sure that the power is switched off before installation. Please read and follow the ‘Installation instructions’ and ‘Safety instructions’ sections carefully before commencing installation.
Installation of this model can change from time to time please read instructions every time before installation. For detailed specification, please go to our website eurotechlighting.co.nz

Code:

| Beam angle:| IP Rating:| Kelvins:| Lumens:| Material:| Optics:| Voltage:| Wattage:
---|---|---|---|---|---|---|---|---
BUL25| 30°| IP67| 3500K| 145lm| 316 Stainless steel, anodised aluminium & plastic sleeve| Symmetrical| 24V DC (Parallel) Driver Required|

3W

Product Information

Installation Instructions

  1. Make sure power is turned off.

  2. Put recessed sleeve into the ground. Make sure to put scoria in the hole for drainage.

    For deck application drill a hole and remote recess sleeve and use a small amount of silicone to secure fitting into place.

  3. Connect cables to your remote driver paying attention to live + neutral markings.

    Blue = Negative
    Brown = Positive

  4. Ensure installation is correct before switching on the fitting to test

Saftey Instructions

Read these instructions carefully before commencing installation.

  1. The light source contained in this luminaire shall only be replaced by the manufacturer or this service agent or a similar qualified person.
  2. This LED luminaire must be installed by a licensed electrician ONLY following all local regulations.
  3. Ensure that the cables will not be squeezed or damaged by sharp edges.
  4. Clean the light with a soft cloth and a standard PH-neutral detergent.
  5. Misuse of/or changes to the appliance shall void all warranties.
  6. Do not install on a surface that is not suitable or deformed.
  7. Do not install on or above a surface with a high temperature.
  8. There should not be any materials that are corrosive, explosive.

For detailed specification, please go to our websiteeurotechlighting.co.nz

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

eurotech lighting User Manuals

Related Manuals