eurotech lighting YBU Series YBU5W3K Cube Bulkhead Wall Light Instruction Manual
- June 4, 2024
- eurotech lighting
Table of Contents
Cube – Bulkhead
Model: YBU & YBL
Installation Instructions
YBU Series YBU5W3K Cube Bulkhead Wall Light
All installations must be carried out by a qualified electrician following
local regulations. Make sure that the power is switched off before
installation. Please read and follow the Installation instructions’ and
Safety instructions’ sections carefully before commencing installation.
Installation of this model can change from time to time please read the
instructions every time before installation. For detailed specifications,
please go to our website
eurotechlighting.co.NZ
Code:| Type:| Dimensions
(mm):| Double
Insulated:| IP Rating:| Kelvins:| Lumens:| Material:| Watts:
---|---|---|---|---|---|---|---|---
YBU5W3K| Up / Down| 100W x 100H
x 75D| Yes| IP65| 3000K| 150lm| UV resistant
Poly-carbonate| 5W
YBL5W3K| Plain| 400lm
YBU8W3K| Up / Down| 200W x 100H
x 75D| 240lm| 8W
YBL8W3K| Plain| 640lm
Product Information
|
---|---
Up / Down – Small
|
Plain – Large
Installation Instructions
- Open the outer cover by sliding a flat head screwdriver along the gap between the cover and the backplate. Open the inner cover with a Phillips screwdriver.
- Drill two holes (5Ømm) N & M, and knock two expansion tubes into the holes. Please refer to the pictures for distance. Then turn the power supply off.
- Feed the wire through the waterproof rubber gasket, peel off the outer wire by 12mm, then peel off the inner wire N, L by 6mm. Connect the wire to N, and L accordingly.
- Take two screws (4Ømm x 30mm), with rubber gaskets, then screw the lamp onto the marked points N, and M.
- Screw the inner cover back onto the lamp properly to ensure a proper seal is made.
- Turn on the power, and test if the lamp is working properly. If yes, then click the outer cover onto the lamp.
Safety Instructions
Read these instructions carefully before commencing installation.
- The light source contained in this luminaire shall only be replaced by the manufacturer or this service agent or a similarly qualified person.
- This LED luminaire must be installed by a licensed electrician ONLY following all local regulations.
- Ensure that the cables will not be squeezed or damaged by sharp edges.
- Clean the light with a soft cloth and a standard PH-neutral detergent.
- Misuse of/or changes to the appliance shall void all warranties.
- Do not install on a surface that is not suitable or deformed.
- Do not install on or above a surface with a high temperature. 8. There should not be any materials that are corrosive, or explosive.
For detailed specifications, please go to our website eurotechlighting.co.NZ
Documents / Resources
|
eurotech lighting YBU Series YBU5W3K Cube Bulkhead Wall
Light
[pdf] Instruction Manual
YBU Series, YBU5W3K, YBL5W3K, YBU8W3K, Cube Bulkhead Wall Light
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>