eurotech lighting LUD2300 Apical Wall Lights Instruction Manual
- June 3, 2024
- eurotech lighting
Table of Contents
eurotech lighting LUD2300 Apical Wall Lights
All installations must be carried out by a qualified electrician following
local regulations. Make sure that the power is switched off before
installation. Please read and follow the ‘Installation instructions’ and
‘Safety instructions’ sections carefully before commencing installation.
Installation of this model can change from time to time please read
instructions every time before installation. For detailed specification,
please go to our website
eurotechlighting.co.nz
Code:| Colour:| Dimensions (mm):| Double Insulated:| IP Rating:| Kelvins:|
Lumens:| Material:| Voltage:| Wattage:|
---|---|---|---|---|---|---|---|---|---|---
LUD1701CCT-BLK| Black| 172L x 82D x 46H| | |
3000K /
4000K /
6000K
| 460lm / 520lm
/ 500lm
|
Polycarbonate
+ ABS with polycarbonate diffuser & UV stable polycarbonate lens
| |
9W
|
LUD1701CCT-WH| White|
| Yes| IP65| | 230V| |
LUD2300CCT-BLK| Black| | | |
230L x 101D x 90H| | | 630lm / 700lm
/ 680lm
| | 12W|
LUD2300CCT-WH| White|
Product Information
Installation Instructions
- Make sure power is turned off. Unscrew Phillips screws on the side and take off the front cover of the fitting.
- Remove the LED lens by removing the 4 screws.
- Gently knock the provided plastic expansion tubes provided into the pre-drilled holes, ensuring the plastic tubes are flush with the mounting surface. Run the power cable through the rubber seal and fix the backplate to the wall.
- Connect the power cable to the connector black paying attention to live + neutral markings.
- Blue = Negative
- Brown = Positive
- Use the switch at the back of the fitting to change the colour temperature.
- Take the front cover off the product and line up the fixing holes of the fitting to the pre-drilled fixing holes on your mounting surface. Fix the fitting with provided screws.
- Fit LED lens back onto the fitting ensuring that screw seals are used and a tight seal is made.
Saftey Instructions
Read these instructions carefully before commencing installation.
- The light source contained in this luminaire shall only be replaced by the manufacturer or this service agent or a similar qualified person.
- This LED luminaire must be installed by a licensed electrician ONLY following all local regulations.
- Ensure that the cables will not be squeezed or damaged by sharp edges.
- Clean the light with a soft cloth and a standard PH-neutral detergent.
- Misuse of/or changes to the appliance shall void all warranties.
- Do not install on a surface that is not suitable or deformed.
- Do not install on or above a surface with a high temperature.
- There should not be any materials that are corrosive, explosive.
For detailed specification, please go to our website eurotechlighting.co.nz
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>