eurotech lighting YBH12W3K-WH Ovate Plain Bulkhead Bunker Light Instruction Manual
- June 3, 2024
- eurotech lighting
Table of Contents
eurotech lighting YBH12W3K-WH Ovate Plain Bulkhead Bunker Light
All installations must be carried out by a qualified electrician following
local regulations. Make sure that the power is switched off before
installation. Please read and follow the ‘Installation instructions’ and
‘Safety instructions’ sections carefully before commencing installation.
Installation of this model can change from time to time please read
instructions every time before installation. For detailed specification,
please go to our website
eurotechlighting.co.nz
Code:| Colour:| Dimensions (mm):| Dimmable:| Double Insulated:| Fixing area
(mm):| IP Rating:| Kelvins:| Lumens:| Material:
---|---|---|---|---|---|---|---|---|---
YBH12W3K-WH| White|
230 x 105 x
58.5
|
No
|
Yes
|
230 x 105
|
IP65
|
3000K
|
1030lm
|
UV resistant ABS + Poly- carbonate
YBH12W3K-BLK| Black
YBH12W4K-WH| White|
4000K
|
1050lm
YBH12W4K-BLK| Black
YBHDIM3K-WH| White| Yes| 3000K| 1030lm
Product Information
-
Product Visual
-
Dimensions
-
Key Point for Installation
After locking the cover board, please do not forcibly push & pull the cable in case of breaking the waterproof seal.Do not install fitting where water can pool in backplate like underneath a timber deck.
Installation Instructions
-
Pre-drill two 6mm diameter location holes on the intended mounting surface, ensuring a depth of 30mm or more for each hole and a distance of 217.5mm
between the two holes. -
Gently knock the provided plastic expansion tubes provided into the pre-drilled holes, ensuring the plastic tubes are flush with the mounting surface.
-
Open the back terminal cover plate of the waterproof termination box with a screwdriver to find the connection terminal & interconnect power cables with
the connection terminal. Note: Make sure the cables run in the provided channels. Reposition the prepared terminal into the box, and screw on the cover
plate. It is important to ensure the cover plate has been installed correctly to maintain IP rating. -
Take the front cover off the product and line up the fixing holes of the fitting to the pre-drilled fixing holes on your mounting surface. Fix the fitting with
provided screws. -
Ensure installation is correct before switching on the fitting to test. Once correct, fit the provided front cover
Saftey Instructions
Read these instructions carefully before commencing installation.
- The light source contained in this luminaire shall only be replaced by the manufacturer or this service agent or a similar qualified person.
- This LED luminaire must be installed by a licensed electrician ONLY following all local regulations.
- Ensure that the cables will not be squeezed or damaged by sharp edges.
- Clean the light with a soft cloth and a standard PH-neutral detergent.
- Misuse of/or changes to the appliance shall void all warranties.
- Do not install on a surface that is not suitable or deformed.
- Do not install on or above a surface with a high temperature.
- There should not be any materials that are corrosive, explosive
For detailed specification, please go to our website eurotechlighting.co.nz
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>