HAWK F8X M2 HP Plus Brake Pads Instruction Manual
- June 2, 2024
- Hawk
Table of Contents
HAWK F8X M2 HP Plus Brake Pads
Specifications
| Component | Specification |
|---|---|
| Sandpaper Grit for Rotors | 130-grit |
| Speed for Initial Stops | 30 to 35 MPH |
| Speed for Hard Stops | 40 to 45 MPH |
FAQ
Do I need to check the brake fluid during installation?
Yes, you should check the brake fluid and flush and replace it as needed.
What should I do if the rotors have deep grooves or scoring?
Rotors with deep grooves or scoring should be resurfaced or replaced as needed.
How long should I wait for the brakes to cool down after burnishing/bedding- in?
Allow 15 minutes for the brake system to cool down after the burnishing /bedding-in process.
Introductions
STREET
Installation instructions should be followed in accordance with the
application-specific brake pad installation instructions provided by the
vehicle manufacturer.
Brake Pad Installation Procedure
- Install brake pads properly. Be sure pads are securely positioned in the caliper.
- Check Brake Fluid. Flush and replace, as needed.
- Check all hydraulic parts for excess wear and tear.
- Check rotor for deep grooves or scoring. Resurface or replace rotor, as needed.
- If rotors do not need resurfacing, then contamination from the previous brake pads must be removed. Sand rotors with 130-grit sandpaper using moderate pressure. Use soap and water to clean rotor surface after sanding. Rotors should be free and clear of oil, grease and brake fluid.
- Inspect calipers for freedom of movement. Lubricate where necessary.
Street Brake Pad Burnishing/Bedding-In Instructions
- To break in the new components, make 6 to 10 stops from approximately 30 to 35 MPH applying moderate pressure.
- Make an additional 2 to 3 hard stops from approximately 40 to 45 MPH.
- DO NOT DRAG BRAKES!
- Allow 15 minutes for brake system to cool down.
- Your brakes are now ready for use and can be driven normally.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>