AIGOSTAR YRSW200-SWL21 Outdoor LED Solar Light User Manual
- June 2, 2024
- aigostar
Table of Contents
AIGOSTAR YRSW200-SWL21 Outdoor LED Solar Light
Please take time to read this leaflet carefully and retain it for future reference.
Diagram
SPECIFICATIONS
200W
- Charging time with solar irradiation is 4-6 hours, but there are many factors due to the processes of usage and region with customers.
- Discharge time: 8 hours
- Timing function: 3H, 5H, 8H
- Another mode is the brightness adjustment mode, which is indicated on the remote control.
- Best effect, recommended use of “AUTO” automatic mode.
- Usually, power on (installed) is defaulted to automatic mode.
- Automatic mode: The brightness of the whole lamp can be adaptively controlled according to the battery’s power.
IMPORTANT SAFETY INFORMATION
- Do not dispose of batteries in a fire. This may result in an explosion.
- Do not expose the light to fire or intense heat as the battery may explode.
- Do not immerse in water.
- Never look directly into the light or shine it into another person’s eyes.
- Follow proper safety tips to prevent from falling off a ladder.
- Consult your local construction safety guide if needed for installing the light fixture on a building.
FIXING INSTRUCTIONS
- The light fixture should be installed on a flat and stable surface.
- The solar charger board should be set in a sunny area where maximum sunlight can be collected.
- Typically, the solar board should face a direction (south) where sunlight can charge the board for at least 3 hours per day (5 hours per day if behind glass). It is suggested to charge the light for 24 hours before first use.
- Use a soft wet cloth to periodically (at least once a year) clean the charger board to avoid the reduction of power output due to accumulated dust.
INSTALLATION
- Fix the bracket of the solar panel on the mounting surface.
- Fixed the solar panel to the bracket.
- Fixed the lamp on the wall.
- Adjust the angle that you need.
- Connect the plug of the solar panel to the socket of the light.
REMOTE CONTROL INTRODUCTION
Note
The first time you use the remote control, please connect the solar panel
to charge and activate the lamp before the remote control can be used
normally.
QUICK SETUP PROCEDURE
WARNING!
- PLEASE KEEP IT AWAY FROM THE CHILDREN.
- THIS PRODUCT CAN BE INSTALLED OUTDOORS, BUT WE SUGGEST THAT AGAINST
- FOR THE RAIN/STORM & HIGH LIGHTS.
NOTE: PLEASE BRING THE FOLLOWING TOOLS
This product should be disposed of responsibly at the end of its life. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice (Waste Electrical and Electronic Equipment Directive)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>