MeTra 95-9406B Dash Kit Instruction Manual
- June 4, 2024
- Metra
Table of Contents
95-9406B
INSTALLATION INSTRUCTIONS
Land Rover: LR2 2008-2012
LR3 2005-2009
Range Rover Sport 2006-2009
95-9406B Dash Kit
KIT FEATURES
- ISO DDIN radio provision
- Painted scratch-resistant matte black
KIT COMPONENTS
- A) Radio trim panel
- B) Radio brackets
- C) (4) #8 x 3/8” Phillips screws
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: See metraonline.com for wiring harness options
Antenna Adapter: 40-EU10
TOOLS REQUIRED
- Panel removal tool
- Phillips screwdriver
Caution! All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the on position, or while the vehicle is running.
DASH DISASSEMBLY
- Unclip and remove the dash panel surrounding the radio.
- Remove (4) screws securing the radio.
- Pull up on the shifter knob to remove it.
- Unclip, unplug and remove the center console panel.
- Remove the (2) screws securing the climate control panel.
- Unclip and remove the A/C vent panel.
- Pull the radio and the climate controls out slightly. Climate control does not need to be completely removed.
- Unclip and remove the radio.
Continue to Kit Assembly
Please visit Metraonline.com for Dash Disassembly illustrations.
KIT ASSEMBLY
ISO DDIN radio provision
- Attach the radio brackets to the radio trim panel using (4) #8 x 3/8” Phillips screws supplied. (Figure A)
- Slide the radio into the completed assembly, and then secure it to the assembly using screws supplied with the radio. (Figure B)
- Locate the factory wiring harness and antenna connector in the dash, and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or AXXESS. Test the radio for proper operation.
- Reassemble the dash in reverse order of disassembly.
If you are having difficulties with the installation of this product, contact
our Tech Support line either by phone at
386-257-1187 or by email at
[email protected].
Before doing so, look over the instruction booklet a second time and ensure
that the installation was performed exactly as the instruction booklet is
stated. Have the vehicle apart and ready to perform troubleshooting steps
before contacting Metra/Axxess Tech Support.
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by enrolling in the most
recognized and respected mobile electronics school in our industry.
Log onto www.installerinstitute.com or
call 800-354-6782 for more information
and take steps toward a better tomorrow.
Metra recommends MECP-certified technicians
http://www.metraonline.com
Metra. The World’s Best Kits ®
MetraOnline.com
© COPYRIGHT 2021 METRA ELECTRONICS CORPORATION
REV. 2/11/21 INST95-9406B