RA-LYNX-RCVR Programming Receiver Instructions
- June 2, 2024
- LYNX
Table of Contents
RA-LYNX-RCVR Programming Receiver
Programming Instructions
Connections
Connecting Power
To set RX5 in 2-CH mode, ensure jumper J3 is open as shown in Table 1. (LED is
not unused in 2-CH mode). AC/DC 12~24V power can either be connected,: from
the door operator to the Power connector, or the DC power supply to the DC
Jack.
Note : ONLY ONE power source can be applied. NEVER connect power to both
power inputs. Upon power connection, both LEDs will flash once.
Connecting Door Operator
Connecting Door Operator(s) in 2-CH Mode
There are 2 channels (CH 1 & CH 2) for controlling up to 2 door operators.
Each channel can be connected to function as Push Button for one door
operator.
Use a pair of bell wire to connect “COM” and “NO” on one channel to the 2-pin
Push Button connector on a door operator. ( Refer to Table 1 for adjusting
control mode if necessary.)
Programming Transmitters
Adding a Code
To program a transmitter, press the switch corresponding to the desired channel (e.g. SW1 for Channel 1).
The corresponding LED will grow for 30, press a button on the transmitter or enter a code on a keypad. When code is programmed the LED will go off.
Upon activation from a programmed transmitter, the corresponding LED for the channel will flash twice. Up to 20 codes can be programmed into a channel.
Erasing Codes
To erase ALL codes for a single channel, press and hold the switch (e.g. SW1
for Channel 1) for 5 seconds until the corresponding LED flashes 7 times.
To erase ALL codes for ALL channels, press and hold SW3 for 5 seconds until
the both LEDs flash 7 times.
For more information, please visit
www.devancocanada.com
or call toll-free at 855-931-3334
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>