Untrammelife YTM06141B01 1 Light Silver Teardrop Crystal Pendant Light Instruction Manual

: May 15, 2024
: Untrammelife

Table of Contents

PREPARING FOR INSTALLATION (Fig. 1)
Read User Manual Online (PDF format)
Download This Manual (PDF format)

INSTALLATION INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Model # YTM06141B01 / YTM210617B01 / UNS01 /YTM210525B01

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

PREPARING FOR INSTALLATION (Fig. 1)

Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to misplace any small parts necessary for installation.
Attach the crossbar (A) to the junction box using screws (C). The side of the crossbar marked “GND” must face out. The junction box is not included.
Determine the desired hanging height and thread tube (I & H & G) to the fixture body (J).
Feed fixture wires through center tube (I & H & G). Connecting center part (I & H & G) to the fixture body (J) and turn clockwise until firmly tightened. Slip collar (F) over the tube, then do the same with the canopy (D).
Connecting swivel (E) to the tube (G) and turn clockwise until firmly tightened, connecting nipple (B) to the swivel (E) and turn clockwise until firmly tightened.
CONNECTING THE WIRES (Fig.2)
Take the black wire from the ceiling junction box and the smooth wire leg from the fixture and twist bare ends together.
Twist wire connector onto end of wire until snug.
Repeat same process with white junction box wire and ribbed wire leg of fixture wire.
NOTE: Twist wires together in the same direction you twist the wire connector onto wires.
If your junction box has a grounding wire (green or bare copper), attach this wire and the bare copper wire from the fixture together as step 1. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
Tuck these wire connections neatly into the ceiling junction box and then raise the canopy (D) all the way to the ceiling. Raise the collar (F) and thread into protruding through.
Attach the crystal ball (K) to the fixture body (J) and turn clockwise until firmly tightened.

Your installation is now completed. Return power to the junction box and test the fixture.
The fixture can change color temperature to 3000K/4000K/ 5000K,which is switched by the extemal on/off switch
Fig. 2

IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING AND INSTALLATION.