Untrammelife UNYH-C-P 1-Light Chrome Crystal Pendant Light Instruction Manual

Table of Contents

Untrammelife-UNYH-C-P-1-Light-Chrome-Crystal-Pendant-Light-
product

Specifications

Preparing for Installation (Fig. 1)

Shut off power at the fuse box or circuit breaker.
Remove the old fixture and mounting hardware.
Unpack the new fixture and lay out all parts in a clear area.
Attach the mounting plate (C) to the junction box (A) using screws (D) with the GND side facing out.

Connecting the Wires (Fig. 2)

Connect the electrical wires as shown in Fig.2, ensuring all wire connectors (B) are secured.
If the junction box has a grounding wire, attach it to the barecopper wire from the fixture. If not, attach the bare copper fixture wire to the green ground screw on the mounting plate.

Finishing the Installation (Fig. 1)

Tuck wire connectors (B) neatly into the ceiling junction box (A).
Raise the canopy (E) to the ceiling and attach it to the mounting plate (C) using ball nuts (F).
Restore power to the junction box and test the fixture.

IMPORTANT: Fixture should be installed by a qualified electrician to ensure proper wiring and installation.

FAQ

Q: Can I install this fixture myself?
A: It is recommended to have a qualified electrician install the fixture to ensure safety and proper installation.
Q: What should I do if my junction box doesn’t have a grounding wire?
A: In that case, attach the bare copper wire from the fixture to the green ground screw on the mounting plate.

Model # UNYH-C-P
READ AND SAVE THESE INSTRUCTIONS

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to misplace any small parts necessary for installation.
Attach the mounting plate (C) to the junction box (A) using screws (D). The side of the mounting plate marked “GND” must face out. $Untrammelife-UNYH-C-P-1-Light-Chrome-Crystal-Pendant-Light- $1$$ The junction box is not included.
CONNECTING THE WIRES (Fig.2) $Untrammelife-UNYH-C-P-1-Light-Chrome- Crystal-Pendant-Light- $2$$
Connect the electrical wires as shown in Fig.2. making sure that all wire connectors (B) are secured.if your junction box has a grounding wire (green or bare copper), attach this wire and the bare copper wire from the fixture together as step 1. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the mounting plate.
FINISHING THE INSTALLATION (Fig.1)
Tuck these wire connector(B) neatly into the ceiling junction box (A) and then raise the canopy (E) all the way to the ceiling. Attach the canopy (E) to the mounting plate (C) using ball nuts (F).