Untrammelife JYG-08 8 Light Black Chandeliers for Dining Room Instruction Manual
- June 17, 2024
- Untrammelife
Table of Contents
INSTALLATION INSTRUCTIONS
Model # JYG-08
READ AND SAVE THESE INSTRUCTIONS
JYG-08 8 Light Black Chandeliers for Dining Room
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig1)
-
Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts in a clear area.Take care not to misplace any small parts necessary for installation.
-
Attach the mounting plate(C) on the Junction box(A) using Screws (D).The side of the mounting plate marked “GND” must face out. The junction box is not included.
-
Pass the lamp body and iron plate (O) through stud on the iron plate (P),In the end,lock them together tightly with cap nut(N).
-
Pass the nipple on the bottom box(M) through lamp body(L) and metal box(K) ,In the end,lock them together tightly with cap nut(J).
-
Screw the fixture loop(l) and Washer(Q)on the lamp body(L).
-
Adjust the chain (H) to the desired length by removing the links if needed and attach one end of the chain to the Fixture loop (l).and then attach the other side of the chain to canopy loop (F).
-
Carefully pass the fixture wires and bare ground wire through the chain (H),canopy loop(F).
CONNECTING THE WIREES (Fig.2) -
Connect the electrical wires as shown in Fig.2. making sure that all wire connectors (B) are secured. If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate using the green screw provided.
FINISHING THE INSTALLATION(Fig.1) -
Pass the canopy through nipple(E)and install it on the mounting plate(C)in the end,lock them together tightly with knurled knon (G).
-
Install bulbs to the socket of arms.
Your installation is now completed. Return power to the junction box and test the fixture.
Notice : It is important to use proper chain pliers (not included) To OPEN and CLOSE the chain included with this fixture. Do not open them with other tools that may twist or stress the chain links. It is important to use proper chain pliers like the ones shown in the diagram. Fig.2
IMPORTANT : FIXTURE SHOULD BE INSTALLEDBYA QUALIFIED ELECTRICIAN TO ENSURE PROPER. WIRINGAND INSTALLATION.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>