SERCOMM RP582B Router or Extender User Manual
- June 4, 2024
- Sercomm
Table of Contents
Sercomm Corporation
RP582B User Manual
RP582B Router or Extender
Copyright© 2022 by Sercomm Corp.
All rights reserved.
Chapter 1: Item in the Box
You will see following items when opening the box RP582B 802.11ax router/extender: 1
Power adaptor (DC IN: 12V/2A): 1
Chapter 2: Prepare to Power On
- Connect the WAN cable to the RJ45 port (Internet)
- Connect the LAN cable to the RJ45 port (Ethernet)
- Connect the power adaptor DC plug with RP582B Power connector, connect the power adaptor to AC Plug
Chapter 3: LED Behavior When Boot Up
LED Color: Blue
LED State: Solid
LED will green breathe(searching for internet connection) after device has
booting.
LED will turn off after Internet is found
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Operations in the 5.15-5.25GHz & 5.85-5.895GHz band are restricted to indoor
use only. Radiation Exposure Statement: This equipment complies with FCC
radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 24cm between
the radiator & your body.
Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.
Industry Canada statement:
This device complies with ISED’s license-exempt RSSs. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution :
(i) the device for operation in the band 5150-5250 MHz is only for indoor use
to reduce the potential for harmful interference to co-channel mobile
satellite systems;
(ii) where applicable, antenna type(s), antenna models(s), and worst-case tilt
angle(s) necessary to remain compliant with the e.i.r.p. elevation mask
requirement set forth in section 6.2.2.3 shall be clearly indicated.
Radiation Exposure Statement:
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
greater than 24cm between the radiator & your body.
Sercomm Confidential Proprietary
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>