STRICH ZEAL Blast Boost Pedal Owner’s Manual
- May 15, 2024
- STRICH
Table of Contents
STRICH ZEAL Blast Boost Pedal
Product Information
Product Usage Instructions
Connection
Connect your guitar to the pedal using a 1/4″ mono signal input. Connect
the output of the pedal to your amplifier using another 1/4″ mono signal
output.
Powering
Use only a 9V AC adapter with a negative tip to power the pedal. Incorrect
power input may cause malfunction or damage.
Controls
Adjust the low, high, and effects level knobs to customize your sound. Use
the switch control to turn the pedal on/off.
Volume Adjustment
Use the high and low knobs to adjust the tone, and the level knob to
control the effects level or volume.
Power On/Off Sequence
When powering up, turn on the power to your guitar amp last. When powering
down, turn off the power to your guitar amp first.
Congratulations on your ownership of this effect pedal. Before using the pedal, please carefully read the manual, which offers important information concerning how to properly operate the unit.
Features
Precautions When Connecting
- To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections.
- Some connection cables contain resistors. Do not use cables that incorporate resistors for connecting to this pedal. The use of such cables can cause the sound level to be extremely low, or impossible to hear. For information on cable specifications, contact the manufacturer of the cable.
- Raise the amp volume only after turning on the power to all connected devices.
- Once the connections have been completed, turn on the power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices.
- When powering up: Turn on the power to your guitar amp last.
- When powering down: Turn off the power to your guitar amp first.
Specifications
- Input Impedance: Min. 100k Ohm; Max. 350k Ohm
- Output Impedance: 300 Ohm
- Recommended Load Impedance: 10 Kohm
- Equivalent Input Noise: -90 dBu or less
- Power Supply: 9V AC adapter
- Current Draw: 10mA
- Dimensions: 115mm (length) x 73mm (width) x 48mm (thickness)
- Weight : 270g
- Accessory : Owner’s Manual
FAQ
Q: What should I do if the sound level is extremely low or inaudible?
A: Ensure proper connections and power supply. Check the settings of the
low, high, and level knobs to adjust the sound output.
Q: Can I use a power supply other than a 9V AC adapter?
A: No, it is recommended to use only a 9V AC adapter with a negative tip to
power the pedal to avoid any damage.