PHILIPS AVENT SCY900 Avent Natural Response Baby Bottle Instruction Manual
- May 15, 2024
- PHILIPS AVENT
Table of Contents
Baby Bottle
SCY900, SCY903,
SCY906, SCY930,
SCY933, SCD837,
SCD838
SCY900 Avent Natural Response Baby Bottle
Read all instructions carefully before use. Keep the user manual and product
packaging for future reference.
For your child’s safety and health
WARNING!
– Continuous and prolonged sucking of fluids will cause tooth decay.
– Always check food temperature before feeding.
– Throw away at the first signs of damage or weakness.
– Keep components not in use out of the reach of children.
– Never attach to cords, ribbons, laces or loose parts of clothing. The child
can be strangled.
– Never use feeding teats as a soother.
– Glass bottles may break.
– Always use this product with adult supervision. It is not recommended to use
a microwave to warm up baby food or drinks. Microwaves may destroy valuable
nutrients in food/drinks and may produce localized high temperatures. If you
decide to use the microwave, take extra care to stir heated food/drinks to
ensure even heat distribution and check the temperature before serving. Only
place the container in the microwave, without the screw ring, teat and cap. Do
not allow children to play with small parts or walk/ run while using bottles.
Always discard any breast milk that is left over at the end of a feed. Inspect
before each use and pull the feeding teat in all directions. Throw away at the
first signs of damage or weakness. Do not use metal inside the glass bottle to
stir contents or for cleaning. This can damage the glass. Do not use bottles
if there are any cracks on or glass fragments in the bottle. Do not use bottle
handles with glass bottles. Prolonged wear or development of scratches may
lead to breakage.
Before first use
Disassemble all parts, clean and then sterilize the parts by placing in boiling water for 5 minutes or sterilize by using a Philips Avent sterilizer. This is to ensure hygiene.
Assembly
Make sure that the feeding teat is fully pulled through the screw ring as
shown in the image (Fig. 1, 2).
Cleaning and storage
Clean all parts before each use to ensure hygiene. After each use, disassemble
all parts, wash in warm, soapy water, remove any food residues and rinse
thoroughly. If you use a brush to clean the tip of the feeding teat, clean it
as carefully as possible to avoid damage. Then sterilize using a Philips Avent
sterilizer or boil for 5 minutes. Make sure that you wash your hands
thoroughly and that the surfaces are clean before contact with sterilized
components. During sterilization with boiling water, prevent the parts from
touching the side of the pot. This can cause irreversible product deformation,
defect or damage that Philips cannot be held liable for. Food colorings may
discolor parts. This product is dishwasher safe. Do not place the product in a
heated oven. Do not bring the bottle parts in contact with or place on
surfaces with abrasive or antibacterial cleaning agents. We recommend
replacing feeding teats every 3 months. Keep feeding teats in a dry, covered
container. Do not leave a feeding teat in direct sunlight or heat, or leave in
disinfectant (sterilizing solution) for longer than recommended, as this may
weaken the teat.
Compatibility
Replacement teats are available separately. To learn more about choosing the
right teat for your baby, visit us at
www.philips.com/avent. These bottle parts are
compatible only with Philips Avent Natural teats.
Support
If you need information or support, please visit
www.philips.com/support.
****www.philips.com/avent
Philips Consumer Lifestyle B.V.
Tussendiepen 4, 9206 AD Drachten, The Netherlands
Trademarks are the property of Koninklijke Philips N.V.
Koninklijke Philips N.V.
son propiedad de Koninklijke Philips N.V.
© 2023 Koninklijke Philips N.V.
All rights reserved.
3000.096.8577.2 (23/11/2023)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>