JUMBO CMD051-2 Scooter User Manual

JUMBO CMD051-2 Scooter

NOTE: Keep fingers away from all moving parts and mechanisms to prevent pinching.

Assemble the handle

1. Open the handlebar clamp
2. Release the handles

Insert the handle s into the clamp, then close the cap

Adjust the height

• Loosen the lock
• adjust the height

Open the scooter

1. open the lock
2. pull up the hock to unfold the scooter
3. close the lock tightly

MAINTENANCE

Frequent inspections should be carried out to ensure that nuts, bolts and fixings are secure and that no parts are worn or damaged.

• Always inspect scooter prior to riding, especially the self-locking nuts and other self-locking fixings.
• Periodically check for undue wear to the wheels and braking mechanism.
• Please replace the wheels if applicable
• It is most important to replace worn or damaged handlebar grips.
• Periodically and sparingly lubricate moving parts with a light oil front axle, rear axle and headset bushes.
• Do not make any modifications other than those mentioned in this instruction.

SAFETY WARNINGS

Please read below instruction before using the scooter.

• Adult assembly required. Adults must assist children in the initial adjustment procedures to unfold the scooter, adjust the handlebar and steering height, and finally to fold the scooter.
• This scooter is not a toy and it must be used under the direct supervision of an adult.
• Not suitable for children under the age of 36 months due to small parts and balls, which could be swallowed or inhaled by young children. To be assembled by an adult.
• Never allow more than one child to use the scooter at one time.
• Minimum user weight: 35kg, maximum user weight: 100kg.
• Always inspect the scooter before use. Check and secure all fasteners before every ride. Replace worn and broken parts immediately. Watch regularly for wheels and brakes worn out and grease the wheel once a year.
• Always wear safety equipment such as helmets, kneepads and elbow pads.
• Always wear appropriate shoes.
• Direct Adult supervision is required. The scooter should be used with caution, as it requires great skill, so as to avoid falling or collision with third parties. Make sure the child is comfortably positioned on the fully assembled and checked scooter. Demonstrate the steering to the child until they have mastered the function and operation of the handlebars and steering assembly. Demonstrate how to safely stop the scooter. The time necessary for a child to master and then co-ordinate each operation can vary considerably. Only when the child has reached a stage where it can balance the scooter, should the child be allowed to use the scooter unassisted, though not unsupervised. Please beware of the potential dangers of using the scooter on public roads.
• The scooter should not be used on hills, steep slopes, roads, and where vehicles or animals may have access or be present. Obey all local traffic and scooter riding laws and regulations. Watch out for pedestrians.
• Ride on smooth paved surfaces away from motor vehicles.
• Avoid sharp bumps, drainage grates, and sudden surface changes. The scooter may suddenly stop.
• Avoid streets and surfaces with water, sand, gravel, dirt, leaves and other debris.
• When used in and around a dwelling the scooter should be kept away from hazardous areas such as kitchens, stairs, patio windows etc.
• Wet weather impairs traction, braking, and visibility.
• Don’t ride at night or during poor visibility.
• Avoid excessive speed associated with downhill rides.
• Do not make acrobatic performances and use always both hands. It is most important that the rider always looks in the direction the scooter is travelling and takes care to avoid other children or unforeseen obstructions.
• Do not use it after consuming any alcohol or drugs.
• Never allow the user to put any part of the scooter in their mouth or to attempt to put any part of his or her body, or any plaything into the moveable or moving parts of the scooter. The rider should be instructed accordingly.
• Remove any sharp edges while using the scooter.
• Brakes will get hot from continuous use. Do not touch after braking.
• Please ensure that you carefully read all instructions contained in this booklet.
• To brake, please engage the braking lever(hand brake) or use the foot to press the rear brake on rear fender

CLEANING

Wipe with a damp cloth to remove dirt and dust. Do not use industrial cleaners or solvents as they may damage the surfaces. Do not use alcohol, alcohol-based or ammonia-based cleaners as they may damage or dissolve the plastic components or soften the decals or decal adhesive. It’s recommended to clean and dry the scooter after each use. Store it in its original carton when not in use. Keep it away from any corrosive materials.

WASTE DISPOSAL : Dispose of the scooter through a private or state recycling agency. Please be aware of the updated official directives. Please contact the recycling agency in case of doubt Bearing maintenance. Keep the scooter in dried environment. Get the scooter back to the store for bearing change.

EN14619 : 2015 Class A

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>