ICE-O-Matic GEMD270A Pearl Ice Water Dispenser Instruction Manual
- May 15, 2024
- Ice-O-Matic
Table of Contents
- GEMD270A Pearl Ice Water Dispenser
- Cabinet
- Condensing System
- Water and Dispensing
- Auger Drive and Evaporator
- Control System
- Wiring Diagram to June 2010
- Wiring Diagram June 2010 and later
- Wiring Diagram From SN 1311128010584
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
SERVICE PARTS MANUAL PEARL ICE /
WATER DISPENSER MODEL- GEMD270A
MODEL NO LONGER AVAILABLE
FOR ALL PARTS MARKED AS NO LONGER AVAILABLE ( NLA) , PLEASE LOOK
FOR REPLACEMENT PART NUMBER IN THE GEMD270A2 PARTS BREAKDOWN.
GEMD270A Pearl Ice Water Dispenser
FOR ALL PARTS MARKED AS NLA PLEASE LOOK FOR REPLACEMENT PART # IN MODEL GEMD270A2 PARTS BREAKDOWN.PARTS
Service Parts
This is a list of Service Parts for the GEMD270A Pearl Ice/Water Dispenser.
Always have the Model Number and Serial Number available when identifing a
Part Number as changes do occur and the change may reference the Model Number
and Serial Number
Cabinet
I t e m N o .| P a rt N u
m b e r| D e sc r i p t i
o n| I t e m N o .| P a rt
N u m b e r| D e sc r i p
t i o n
---|---|---|---|---|---
1| 1011357-136| Foam Pad| 16| 1011357-138| Label – I c e &
Water Selection
2| 1011357-112| Left Side Panel| 17| 1011357-83| Label – Ice & Water
3| 1011357-113| Right Side Panel| 18| 1011357-139| l c e –
O – M a ti c Label
4| 1011357-114| Riaht PCB Service Panel NLA| 19| 1011357-133| Top Panel
5| 1011357-108| Rear Panel| 20| 1011357-140| PCB Cover
6| 1011357-107| Metal Bracket for Fitting NLA| 21| 1011357-101| PCB Housing
7| 1011357-109| Cover for Fitting Bracket| 26| 1011357-25| Screw
8| 1011357-106| Metal Divider| | 1011357-78| Cap for Screw
9| 1011357-93| Condenser Shroud| | 1011357-79| Washer for Screw
10| 1011357-96| Plastic Bracket| 27| 1011357-26| Side Panel Screw
11| 1011357-110| Ice Spout Bracket| 28| 1011357-27| Back Panel Screw
12| 1011357-95| Dispense Board Frame NLA| 29| 1011357-87| Drain Fitting NLA
13| 1011357-162| Front Panel-No L a b e l s| 30|
1011337-34| O-Ring NLA
14| 1011357-137| Grill, Sink| 31| 1011337-32| Drain Top
15| 1011357-97| Dispensing Spout NLA| 32| 1011357-136| Foam Pad Under Base
*Units Manufactured Prior to Serial Number 0508 Will Require The Front and Top Panel Kit PN 1011357-173
Condensing System
Item Number | Part Number | Description |
---|---|---|
1 | 1011357-105 | Compressor Assembly*Use a Tecumseh AE4450YAA- NO LONGER |
AVAILABLE
1| 1011357-164| Compressor Assembly- From Serial Number 13111280010584
5| 1011357-142| Protector* No Longer Available
5| 1011357-165| Protector- From Serial Number 13111280010584*
9| 1011357-33| Start Relay No Longer Available
9| 1011357-166| Start Relay-From Serial Number 13111280010584
10| 1011357-35| Start Capacitor* NoLonger Available NLA
10| 1011357-167| Start Capacitor-From Serial Number 13111280010584*
12| 1011357-67| Valve Body NLA
13| 1011357-103| Valve Core NLA
14| 1011357-65| Valve Cap NLA
15| 1011357-44| Air Cooled Condenser NLA
19| 1011357-42| Fan Motor NLA
20| 1011357-43| Fan Blade NLA
21| 1011357-169| Fan Motor Bracket
25| 1011357-49| Drier NLA
26| 1011357-121| Suction Line/Accumulator/Cap Tube
26| 1011357-170| Suction Line/Accumulator/Cap Tube – From SIN
13111280010584**
*Red=Units Manufactured Prior to and including Serial Number 13111280010583
**Green=Units Manufactured from Serial Number 13111280010584
ALL PARTS NLA- LOOK in GEMD270A2
Water and Dispensing
Item| Part|
---|---|---
No.| Number| Description
1| 1011357-116| Water Inlet Fitting
2| 1011357-63| Strainer
3| 1011357-13| Fiber Washer
4| 1011357-14| Nut
5| No PN| Copper Water Inlet Tube NLA
6| 1011357-143| Water Inlet Valve
7| 1011357-171| Water Hose, 4 required
8| No PN| Copper Water Inlet Tube NLA
9| 1011357-119| Nozzle
10| 1011357-24| Clip Ring
11| 1011357-61| O-Ring NLA
12| 1011357-124| Water Reservoir Assembly
13| 1011357-91| Float Valve Assembly NLA
14| 1011357-115| Water Level Metal Pin NLA
15| 1011357-89| Water Reservoir Cover NLA
16| 1011357-30| Plastic Tube
17| 1011337-38| Water Drain Fitting NLA
18| 1011357-90| Plastic Ring Nut
19| 1011357-144| Plastic Tube
20| 1011357-65| Valve Cap NLA
| 1011357-67| Valve Body NLA
21| 1011357-31| Plastic Tube
22| 1011357-94| Gear Motor Plastic Cover NLA
23| 1011357-09| Insulation
24| 1011357-09| Insulation
25| 1011357-73| Insulation NLA
26| 1011357-73| Insulation NLA
27| 1011357-72| Spout Insulation
28| 1011357-98| Ice Spout NLA
29| 1011357-145| Ice Spout Cover NLA
30| 1011357-131| Storange Bin
31| 1011357-81| Insulation,Storage Bin Cover
32| 1011357-92| Cover, Storage Bin
33| 1011357-130| Bracket, Dispensing Motor NLA
34| 1011357-11| Dispensing Motor
35| 1011357-111| Cover, Dispensing Motor
36| 1011357-04| Screw
37| 1011357-03| Shaft
38| 1011357-129| Ice Agitator 1011357-129
39| 1011357-02| Pin, Vane
40| 1011357-128| Bin Bottom 1011357-147
41| 1011357-57| Rubber Washer
42| 1011357-148| External Drain Hose
43| 1011357-149| Nut
Item 38 and 40 need to be ordered as a set.
ALL PARTS NLA, LOOK FOR REPLACEMENT IN GEMD270A2 PARTS BREAKDOWN.
Auger Drive and Evaporator
Item| Part|
---|---|---
No.| Number| Description
1| 1011357-126| Gear Reducer Assembly NLA
2| 1011357-01| Gear Case Assembly NLA
3| 1011357-07| Gear Case Lubricant (1 Kg) NLA
4| 1011357-05| Screw NLA
5| 1011357-150| O Ring NLA
6| 1011357-58| Grease Seal NLA
7| 1011357-85| Bearing NLA
8| 1011357-23| Thrust Washer NLA
9| 1011357-125| Rotor Assembly NLA
10| 1011357-37| Stator Assembly NLA
11| 1011357-117| Fan Blade NLA
12| 1011357-60| Rubber Insert NLA
13| 1011357-127| Drive Motor Cover NLA
14| 1011357-172| Capacitor NLA
15| 1011357-06| Screw NLA
16| 1011357-70| Plastic Housing NLA
17| 1011357-19| Screw NLA
18-19-20| 1011357-123| Magneto Holder Assembly NLA
21| 1011357-51| Grease Seal NLA
22| 1011357-168| Drip Tray
23| 1011357-56| Gasket NLA
24| 1011357-08| Coupling NLA
25| 1011357-17| Screw
26| 1011357-20| Washer
27| No Number| Freezer Assembly NLA
28| 1011357-118| Aluminum Adapter NLA
29| 1011357-151| Evaporator** NLA
30| 1011357-18| Screw NLA
31| 1011357-20| Washer
32| 1011357-76| Auger NLA
33| 1011448-95| Water Seal NLA
34| 1011357-153| Lower Bearing NLA
35| 1011357-55| O Ring NLA
36| 1011357-154| Ice Breaker(Includes 36,37, 41,42)NLA
37| 1011357-54| O Ring NLA
38| 1011357-15| Screw NLA
39| 1011357-20| Washer
40| 1011357-53| O Ring NLA
41| 1011357-104| Top Bearing***
42| 1011357-69| Clip Ring NLA
43| 1011357-74| Ice Sweep NLA
44| 1011357-16| Screw NLA
45| 1011357-12| Water Proof Grease NLA
46| 1011357-185| Nylon Ring, upper bearing NLA
NOT SOLD As An Assembly
Gear Reducer Assembly INCLUDES Motor, DOES NOT Include Evaporator Components
Gear Case Assembly INCLUDES the EXTERNAL SHELL ONLY
*NOT SOLD As An Assembly
*Evaporator is NOT FOAMED, see PAGE 5, ITEM 24 for the Insulation Wrap
Top Bearing 1011357-182 is NLA
ALL PARTS NLA, LOOK FOR REPLACEMENT IN GEMD270A2 PARTS BREAKDOWN.
Control System
Item| Part|
---|---|---
No.| Number| Description
1| 1011357-155| Box Only
2| 1011357-156| Cover
3| 1011357-48| PC Board (8 Pin Plug)
3| 1011357-174| PC Board Kit NLA
3| 1011357-175| PC Board (7 Pin Plug) NLA
5| 1011357-99| Dispensing Selector
6| 1011357-41| Water Sensing Wire
6| 1011357-176| Water Sensing Wire NLA
7| 1011357-39| Hall Effect Sensor NLA
8| 1011357-157| Condenser Sensor*
8| 1011357-177| Condenser Sensor* NLA
9| 1011357-40| Evaporator Sensor
9| 1011357-178| Evaporator Sensor NLA
10| 1011357-71| Ice Level Control
11| 1011357-47| Dispensing Sensor (Black) NLA
12| 1011357-46| Dispensing Sensor (Blue) NLA
13| 1011357-159| Harness Dispensing Sensor NLA
14| 1011357-50| Contactor* NLA
15| 1011357-160| Dispensing LED Board
16| 1011357-161| Dispensing Switch Panel
17| 1011357-179| Cable Holder
18| 1011357-183| Connector Adapter**
*Red=Units Manufactured Prior to “LATE 2014”
Note: If the PC Board or any Components are NLA then use the “Retrofit Kit”
**Green=Units Manufactured from “LATE 2014” – ALL PARTS NLA, LOOK FOR
REPLACEMENT IN
GEMD270A2 PARTS BREAKDOWN.
Note: Item 1011357-174 PC Board “Retrofit Kit” includes:
1011357-175 | PC Board NLA |
---|---|
1011357-178 | Evaporator Sensor NLA |
1011357-177 | Condenser Sensor NLA |
1011357-176 | Water Sensing Wire NLA |
1011357-183 | Connector Adapter |
Wiring Diagram to June 2010
Wiring Reference
Position of wiring is common, color of wires is not.
Controller Example from before 2010, Others (6/2010 and later) have only 1
white wire., plus water valve and auger motor wire colors switched.
Wiring Diagram June 2010 and later
Wiring Diagram From SN 1311128010584
PC BOARD
PC BOARD – CARTE ELECTRONIQUE
CALIBRATION OF THE I/RICE LEVEL CONTROL
At tme of installation it’s necessary to perform the calibration of the I/R Ice Level control.
- Switch OFF the machine at External Switch
- Push and hold the PC Board Push Button
- Switch ON the machine at Extemal Switch
- Wait few seconds till all LEDs of the PC Board are ON
- Release the PC Board Push Button
The I/R Ice Level control is now calibrate
NTC PC Board 660448 09
NTC PC Board 660448 09 or the kit 060711 21