OKM B08HW24ZZP 3D Ground Scanner Fusion Professional User Guide

Table of Contents

Specifications:

Initial Setup:

First Measurement:

Configure 3D Ground Scan in Visualizer 3D Studio:
- Sonden-Ausrichtung: Vertikal
- Field Length: 10 m (33 ft)
- Scan Mode: Parallel
- Probe Orientation: Vertical
Go to the starting point of the first scan line (bottom right corner of the scan field).

Operating the Device:

Hold the Probe in your hand and power it on. Note the orientation of the Probe.
Establish a connection between notebook and Probe by using the Trigger on the Probe or in the Visualizer 3D Studio software.

Scanning Process:

Scan the first line at a constant speed until you reach its end (indicated by an acoustic signal).
Move parallel to the first scan line, press the trigger to start scanning, and walk parallel to the first line without scanning.
Repeat scanning process for additional lines by going to the next starting point and scanning to the end of each line.

Further Support:

For more information and support, visit:

Q: Can I use the Fusion Professional without connecting it to a Windows notebook?

A: No, the Fusion Professional requires a Bluetooth connection to a Windows notebook for operation and data transfer.

Q: How do I know when the device is fully charged?

A: The LED on the Control Unit will turn off when the device is fully charged.

LIVE SOUND
Acoustic and visual magnetic field measurement to detect metal objects near the surface.

OKM-B08HW24ZZP-3D-Ground-Scanner-Fusion-Professional-
FIG-1

3D GROUND SCAN
Graphical ground measurement with visualization in 3D for detailed analysis in Visualizer 3D Studio.

OKM-B08HW24ZZP-3D-Ground-Scanner-Fusion-Professional-
FIG-2

Do not drink any alcohol or take any drugs before or during the operation of the device and follow the instructions carefully!

Read all instructions first before commencing the assembly and usage!
Read the user manual!

Plug Charger into Control Unit to check charge status (fully charged = LED off) and recharge batteries (LED on).
Hold Probe in your hand and power it on. Note the orientation of the Probe.
Establish a connection between notebook and Probe (see DATA TRANSFER).
Start controlling the detector via Trigger on the Probe OR in the software Visualizer 3D Studio.

OKM-B08HW24ZZP-3D-Ground-Scanner-Fusion-Professional-
FIG-3

Pair your Fusion Professional via Bluetooth with your Windows notebook. Open software Visualizer 3D Studio and start import.
Select Fusion Professional (version 2.0 or higher) and enter scan parameters in the dialog windows.
Perform a scan with Fusion Professional. Finish the scan by pressing and save the scan on the notebook by pressing

Open Visualizer 3D Studio, start import and configure 3D Ground Scan:
Field Length: 10 m (33 ft) Scan Mode: Parallel Probe Orientation: Vertical
Go to the starting point of the first scan line (bottom right corner of the scan field).
Start walking as soon as you press the trigger.
Walk at a constant speed.

OKM-B08HW24ZZP-3D-Ground-Scanner-Fusion-Professional-
FIG-8

Scan the first line at a constant speed until you reach its end. The end of the scan line is indicated by an acoustic signal.
Go to the next starting point without scanning. Press the trigger to start scanning and walk parallel to your first scan line.
Go to the next starting point and scan to the end of the line. Repeat this to scan as many lines as you like.
Finish the scan by pressing and save the scan on the notebook by pressing

OKM-B08HW24ZZP-3D-Ground-Scanner-Fusion-Professional-
FIG-4