XENITH Back Plate and Core Guard Instruction Manual
- June 12, 2024
- XENITH
Table of Contents
BACK PLATE & CORE GUARD
ASSEMBLY INSTRUCTIONS: XENITH SHOULDER PADS
HARDWARE CONTENTS
2 T-Nuts
2 Screws
STEP 2 – ALTERNATE 
Locate the slot or hole along the lower edge on the back
of your shoulder pads. Place a tnut through your chosen grommet in the Back
Plate attachment strap. Slide the attachment strap and t-nut behind the outer
shell of the shoulder pad to align with the slot. Install a screw through the
slot from the outside and into the t-nut to secure. Do not over tighten.
Repeat for the other side.
STEP 1 
Align the back plate with the lower edge of your shoulder
pads. Select the grommet holes that will position your Back Plate closest to
the desired position. NOTE: The straps may need to be angled in or out to
align with the holes in your shoulder pads.
STEP 3 – ALTERNATE
After attaching the straps on both sides, make any
adjustments to the straps to ensure the Back Plate is hanging centered on the
shoulder pads. If an adjustment to the vertical position of the Back Plate is
desired, a different set of grommets can be used to raise or lower the Back
Plate position.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>