BOCCI 84.6 Stem Ceiling Mounted Instruction Manual
- September 3, 2022
- BOCCI
Table of Contents
BOCCI 84.6 Stem Ceiling Mounted
Product Overview
- PENDANTS: six
- MOUNTING: 142mm (5.6”) x 35mm (1.38”)
- LAMPING: 1.5w LED
- STEM LENGTH 1.8m (6’) long stem
- ADDITIONAL 153mm (6”) / 305mm (12”) / 914mm (36”) /
- EXTENDERS 1524mm (60”)
- MATERIALS: blown glass, electrical components, unlacquered brass or black powder coated brass stem, black or white canopy
- WEIGHT: approximately 14.5kg (32lb)
- POWER SUPPLIES: integral
DESCRIPTION
The stem ceiling mounted system comes in unlacquered brass or black powder
coated stem with a 142mm (5.6”) diameter mounting plate rated for ceiling use.
A white glass bubble is captured inside a fi ne copper mesh basket and then
plunged into hot clear glass. Air is blown into the matrix to gently push the
white glass through the mesh, creating a delicate pillowed form that is
suspended inside the thick outer layer of clear glass. Sometimes the copper
mesh basket folds and crinkles, adding specifi city to each piece.
NOTES
- Purchase replacement lamps online at www.bocci.com/shop/bulbs
- Power supply can be remote mounted with 94mm (3.7”) x 6mm (0.24”) canopy.
- The brass used in our Stem Series is untreated and, as such, will develop a natural patina over time. To avoid any marking or tarnish on the brass during handling and installation, please use the gloves provided in your shipment.
- To maintain your fi xture, please regularly dust with a lint-free cloth. If further cleaning is required, dampen a lint-free cloth with water only and wipe gently to remove dust or debris.
Instructions
-
Thread the cover cap on one end of the stem.
Note: Bocci recommends wearing thin gloves during installation to protect the stem fi nish and the glass surface. -
Connect the stem pieces by threading the stem connector to the stems.
Note: This step is only necessary for overall stem lengths longer than 1.8m (6’). -
Thread the pendant mounting plate onto the stem.
Carefully insert provided lamp into socket. -
Connect power supply to line voltage.
-
Connect input low voltage wire to 12V DC output wires by feeding the wires through the slots on the mounting plate.
-
Connect the black wire to line wire and white wire to neutral wire.
-
Ensure that line voltage is not active during this part of the installation!
Note: As an option, Bocci recommends mounting power supplies remotely in a close, accessible and hidden location for ease of long term maintenance. Installation to be done by certifi ed personnel to ensure compliance with the code. -
The client is responsible to ensure fasteners are attached to a robust structural substrate. Affix mounting plate to surface with fasteners provided. Thread canopy cover onto the mounting plate. Thread on the stem to canopy. Turn power to fixture on.
-
Gently thread pendant onto the stem. Be sure to carefully place the pendant so as not to damage the lamp during installation..
Clean fi ngerprints from fi xture surfaces.
For additional assistance,
please contact Bocci:
[email protected]
[email protected]
www.bocci.com
US Patent Pending
EU Patent # 003611144-0001 to 0004
Made in Vancouver, Canada