VELOSSA TECH 2014-2022+ Toyota 86 FRS BRZ BIG MOUTH Ram Air Installation Guide
- June 4, 2024
- VELOSSA TECH
Table of Contents
Kit Contents (Full Kit)
Please review this document before attempting installation.
You will need basic hand tools and 2 hours of installation time.
| Kit Contents | Qty |
|---|---|
| M6 x 25mm Cap Screw | 2 |
| #8 x 3/4″ Flat Head Phillips Screw | 6 |
| Push Retainer Clip | 1 |
| M6 Lock Nuts | 1 |
Stock Components Removal
It is best to google “how to remove bumper” for your particular trim, after the bumper is removed, you will see the following.
Big Mouth Installation
The top of the BIG MOUTH slides into position as shown, DO NOT fasten yet. Keep it loose so the bottom section can easily slide into position.
Bracket 3 Installation
The bottom section first needs Bracket 3 to be installed, do not tighten the
screws all the way yet.
These screws should be left somewhat loose until you position the bottom body
correctly.
Bracket 1 Installation
Slide the bottom section of the BIG MOUTH into the position as shown, it should tuck under the top half of the BIG MOUTH assembly. Begin to screw in Bracket 1, and ensure that the dovetail joint that hooks into the body is secure.
You may slide in bracket 1 from the side so the hook engages the body.
Bracket 2 Installation
Bracket 2 will be installed similarly to bracket 1. Engage the hook and screw by hand slowly, note the 45-degree angle by which to insert the screws. Be patient with alignment.
Clip Bracket 3
All brackets should be in place. You will need to go under the crash bar and
insert the supplied Christmas-tree clip to fasten bracket 3 to the crash bar
(there is a hole in the crash bar).
Tighten Bracket 3
Once Bracket 3 has been clipped into the crash bar, you may tighten these
screws with a Phillips screwdriver. The slots in the bracket allow there to be
an adjustment.
Clip Brackets 1 and 2
Insert the OEM clips as shown. These clips will securely snap brackets 1 and 2
into the crash bar.
Fasten Upper Section
Once the lower body is secure, you may fasten the upper body as shown.
Final Assembly Review
Review the install and make sure nothing is binding or causing any preload on any parts, loosen and retighten if an adjustment is necessary.
Re-assemble the bumper the same way it was removed to complete installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>